开云体育

Alan, Interesting, this was not what Neal Barry said from his experience on this issue. It's no big deal to change out the bearings and/or shim the shaft, so we will see if you are correct on this. I

On Sun, Jul 11, 2021 at 10:58 PM, John Kmetz wrote: > > This information is pretty interesting, Peter. If you have some pics of > the mount with the bearings removed would love to see them. In fact,

Yes, the shaft rattles, but that only has the saddle attached to it.? This does not affect the worm and ring gear engagement since that is set by a separate set of bearings that do not wriggle.?

This information is pretty interesting, Peter. If you have some pics of the mount with the bearings removed would love to see them. In fact, there should be a file section here for mount disassembly

Chip, *> Surely the bearing blocks are sitting flush on the deck plate and not as is shown in the photos way up off the base deck!* Yes, of course. I figured showing a picture of bearing blocks in

I was asked to start up a sperate thread on this subject, which I think is a good idea as this is a significant issue for some. After making numerous mods, I now realize I should have looked at this

Lol I’m glad it worked. I discovered the problem by following the scientific method: put it in my pocket during boot up and got it misconfigured by mistake :D Guilherme

You nailed it, Guilherme- many thanks!! Sam Sent from Mail for Windows 10 Sent: Saturday, July 10, 2021 9:59 PM To: [email protected] Subject: Re: [Losmandy_users_io] Hand box controller

I’d love to but I ha e a DSLR and I don’t think that’s possible my plan is get the 290 and use it with same guide scope. Then this will transfer over to a good OAG camera once I upgrade to an

Can you use an OAG? Going from Orion ST80 with the Orion Star Shooter Auto Guider Camera to a QHY-M OAG and ASI174mm camera was a game changer for me.? Now multi-star guiding with 12 stars selected.

I have just carefully adjusted both my DEC and RA worms using finger pressure to squash the two ends together and feeler gauges to adjust the gap between the body and the non-motor adjustment block.

Thanks! I am going to check this out. Unless DEC affects the RA, then it is less of a concern right now, although might need some attention When I imaged at DEC=60, RA was insanely good. Last night

Hi Greg, Surely the bearing blocks are sitting flush on the deck plate and not as is shown in the photos way up off the base deck! -- Chip Louie Chief Daydreamer Imagination Hardware Astropheric

I have a very long post describing the DEC axis backlash /g/Losmandy_users/message/71205

Please start another thread to discuss this

I'll confess .... ... once I plugged my G-2 hand controller cable into the wrong G-2 port by mistake. The HC booted up! But nothing worked of course to operate the Gemini-2. I then thought my G-2 was

Totally correct...first thing is re-calibrate the HC screen on boot.? Try this is first. The fact got past into screens...means it appears to be working so maybe re-seat your HC microSD card. Dos

Past replies on the forum have suggested that if the HC housing screws are too tight the touch screen may not not work properly. Try loosening and re-snugging be hand.

Did you try re-calibrating the screen? Right before the boot options menu shows up you can press the screen to re-calibrate it. Guilherme

Recently, the handbox connected to my Gemini-2 controller will turn on, initialize and go to the start page (“warm” “cold” etc) but then become completely unresponsive to the touchscreen to