开云体育

Hi, Derek I used an ASI120 MC for several years. Lots of successes, but many issues, too. Locked up alot with my ASI other imaging camera and DSLR. Lost stars a lot. or only detected a few...maybe

Which proves the point. Set the mount outside and about midnight or so go out and set the backlash on the now cold normalized mount. Be sure to run the servos at least 360 degrees, you will need to

Hi Derek! Long time sir! Absodarnedlutely possible to autoguide using an OSC but highly not recommended. The issue is due to the way OSCs work it is possible that the autoguiding will have issues

Hi Ralf, You should have two SVM-HTS for a new mount with tucked in motors. Just call Tanya and she will get you fixed right up. -- Chip Louie Chief Daydreamer Imagination Hardware Astropheric Weather

Sorry for late reply;? ASI2600MC LOVE IT!!!? Best camera I have ever worked with and obtaining spectacular images.? After processing my images, its like coming right out of any magazine!!? Loving

My interest is in Astro Imaging. My logic is if I can image it, then viewing it will come easy, too. Just decide on different telescopes. My decision making flow was, 1. *IF* I wanted to venture from

It is hard to beat the Losmandy G11G for stability when sitting on a Losmandy Folding HD tripod or my favorite, the Berlebach Planet tripod. You really want a solid tripod, the FHD is heavier but is

My suggestion is to find a local Losmandy owner and tag along on an observation session and as questions. A local astro club is a good place to start looking for someone who is willing to share their

other is using JNow? That's a good one to check, David david.partridge@...> wrote: -- Brian Brian Valente portfolio brianvalentephotography.com <http://brianvalentephotography.com>

My guess is that one piece of software is using J2000 epoch and the other is using JNow? Can you check that? Davi

It sounds like you just need to plate solve and sync the mount so they are in agreement [email protected]> wrote: -- Brian Brian Valente portfolio brianvalentephotography.com

I'm hoping that someone can help with this problem. I'm control a Losmandy G11 using ACSOM driver for Gemini II. The picture shows of the problem. I've researched this but to no avail. NINA shows the

Very wise counsel from W Maxwell. ?The most difficult part about buying new gear is understanding what you own expectations are vs. your budget. ?Once you get that worked out, the rest falls into

The following photos have been updated in the JMD G11T ( /g/Losmandy_users/album?id=254767 ) album of the [email protected] group. * alnitak calibrated master stack.jpeg (

Peter good point. That’s corrosion and oxide growths the potting stopped this formation. ?The socket needed replacement (bugger of a job but can be done ) . It looks to be moisture causing this

I received the GM811G over the summer and my instructions indicated that the RA and DEC motors ARE IDENTICAL (both are SVM-HTS); mine is the basic system;? and it does not matter which motor goes

Thanks all, yes I did reset the worm gears indoors a while ago, it wasn't too cold outside last night but it was very heavy with condensation, everything was dripping wet, tried it today indoors with

Never had balance make the backlash too small on my GM8 Gemini 1 OR v1.05 mounts. That just means the backlash was set incorrectly for the temperature. Set the backlash on a cold mount and the issues

Yes, that was that. I tightened them and it is now solid. Thank you. ________________________________ Sent: Saturday, November 28, 2020 6:24 PM To: [email protected] <[email protected]>

Thanks, Brian. We should have clear skies tomorrow night, so I can give it a go. Matt