开云体育

A bit late to the thread but, having had my share of exposure to Belleville washers (thanks Michael!), and involuntary worm gear practice, let me chime in.? On a recent episode of Gold Rush, Tony had

Thanks for your reply. I was wondering if you could clarify what you mean when you say "calibrate" the hand control screen. Ince I'm automatically taken to? the "cold start, warm start, etc.", screen

Seb, This looks like it could be a flattener spacing and sensor tilt problem. Looking at the corners you have a spacing problem but the bottom is not as bad, almost perfect. This tells me you have a

Luis, This situation is why the G11T and the TRA-Axis exist, just to boost your G11 up to a 75 pounds imaging payload. -- Chip Louie - Chief Daydreamer Imagination Hardware

Henk, Is this repeatable? Does it happen in both directions??It looks like you kicked the tripod or the camera or focuser flopped. I suggest a careful retest making sure you don't have a loose screw

I have a G11G mount in my ROR observatory. Usually the weight of my instruments is about 17 kg (38 lbs). I’m thinking to buy a Celestron14 Edge that weights 21 kg (47 lbs). Then the total weight of

Its a refractor , so it should not lose collimation. I will check collimation anyway on a bright star next time. My guiding wasn't too bad. If it was guiding, stars would be more elongated on frames

Maybe your collimation is out? Mine was out a few days ago and it looked alot like that. I have an SCT, so it needs adjustment on occasion. How was your guiding?

Please look at those light frames and compare. Same egg shaped stars on all of them. 5 sec or 300 sec exposure time?doesnt make any difference. 5 sec

Brian, that's a good idea, will do. I haven't been motivated to do that yet since my current guiding is good enough for now. But the upcoming full moon days would be a good opportunity.

1st thing to do: Calibrate your HC screen. 2nd: Grit or a smal particle (or even too much pressure from the LCD “frame” rubber pad itself) gets caught in the edge or this LCD pad which causes the

Just to be clear, I did not mean to say that there is anything wrong with this.? There always will be some play in the axes in order to not bind up.? This happened to my AVX one time, and I had to

As part of my polar alignment procedure I put the G11S mount in the home position with the scope pointed at the NCP with a camera at 6400 ISO at prime focus.? I then rotate around the RA axis, mark

Hi Jeffrey I don't see a message Soo if you could resend that would be great. We are on location until Monday so I may not be able to respond until then Brian wrote:

Hi Brian, I don't know if you got my last private message.? I sent a log file of a recent guide experiance.? The last time, a year ago, you mentioned I had a huge periodic error on a chart you

I just completed the initial setup of the Gemini on my new G811. I shut it off and then later turned the system back on. I tried touching Cold Start and nothing happened. After a few more tries the

Arun you don't have to wait for that - you can use the baseline guiding outline I posted to this thread, complete that and then upload to the PHD Forums Brian -- Brian Brian Valente portfolio

That looks a lot like my graph. I want more as well. Hopefully the guiding workshop will discuss whether and how this is possible.

Not sure what all you are trying to power on Brian but recently I started using the Kasa wifi power strip over home wifi:

Hi Tim, I should've been clearer: Gemini.NET ASCOM driver uses HTTP protocol over port 80, or UDP protocol over port 11110 (by default) Regards, -Paul