开云体育

You're right "it just kind of looses it", is vague. Just as some background, it may just be my setup because I've been compiling the components from source and usually using the "master" branch so

Hi Jamie that's not a lot to go on - if you have some logs to look at that would help i'm not sure i know what "it just kind of looses it" means? when a slew command is issued via UDP, there isn't

I have a GM811G with spring loaded worm. I've found that increasing RA aggression is key to keeping the RA in check. I'd experiment with that value and see if it improves things. I've found that I can

Hi Sebastian, I had a very light side by side setup as you have, even with 3 steps balancing I have always encountered balancing issues, very difficult IMO. You still could check this guide for

Taylor: Here is my process for the newer OPW which is basically your's, but a bit more involved because of the Oldham coupler alignment .? This is mostly because with its design, the coupler is

OH, and I just tried setting the indi losmand connection to tcp with port 4030, and I get an error: 2020-05-20T05:34:24: [ERROR] Error reading from device Read Error: Resource temporarily unavailable

I often have issues with the mount just kind of "loosing it!". It's usually with a slew, and I either have to send the stop command or turn it off.? My setup is ekos/indi/skysafari and I'm using the

HC plugged into HC port as it should be.

What is it doing (or not doing)? It’s hard to tell from the photo … is your hand controller plugged into the port labeled “Serial Port 2 Graphic HC” (and not the port labeled “Classic Hand

Sitting in my garage next to my mount and waiting for a clear night. But not tonight ...

I should say "normally" it doesn't make a difference. It sounds like you may want to add a touch of grease in there, especially if you are cleaning with ipa. Thermal expansion/contraction could

For me, it makes a difference . If I leave the clutches disengaged for a few days, it is difficult or impossible to tighten them later. I had to clean them with IPA to work properly.

Oop sorry - i didn't see the belleville washer mod Michael Herman probably has better input specific to that [email protected]> wrote: -- Brian Brian Valente portfolio

A) yes B) don't remove the DEC axis, but depending on the counterweight you may want to remove that sebkotulski@...> wrote: -- Brian Brian Valente portfolio

Hi Sebastian it makes no difference. Personally I leave them tight (not hard tight, but tight) because often I grab the mount and put on the telescope without thinking, and sometimes that has bitten

Hello, If I want to adjust the RA axis worm, should I : A) remove the scope from the mount? B) remove the whole DEC axis with counterweight? Sebastian

Hi, when not in use, should I leave the mount with clutches on or off? I mean fully tightened ?or just a liitle to secure the ota?

Got it working with the mount. ?Thanks

Hi Tim, I believe you'll need the ASCOM plugin for TheSky 6 to connect using ASCOM driver.? TheSky X might be different. Take a look

Folks I’ve installed the ASCOM driver on my laptop. ?I selected Gemini in TheSky drop down. ? I’m using a USB connection. ?Is there anything else I need to do before connecting? ?I don’t