开云体育

With the DEC cloth unlocked I can move the OTA around and it holds position (same for RA). The stall is happening immediately. The axis isn’t even beginning to move in either direction. I hear a

Is it possible you are not balanced on the DEC axis? It should be roughly balanced with a little bias towards the camera Thanks Brian Brian Valente Brianvalentephotography.com Sent:

Hi, I just received my GM811 today and I’ve been setting it up and testing indoors to get familiar (it is, of course, raining here in northern Virginia). I have everything hooked up (RA and DEC

Michael, I do understand the caution about removing the anodizing, but I think the worm wheel is made of 7075 aluminum, which is a very tough alloy. The pluses would outweigh the cons. Don

Thank you Chuck, I appreciate learning of that better method. Best, Michael Losmandy_users@...> wrote:

Michael While alcohol is a good cleaner, it can absorb moisture later.? Moisture and electricity leads to corosion/dendrites.? If you can, after cleaning with alcohol, further clean it with

Don, Ohers have also reported lapping helped, but Losmandy says it wears off the anodization on the ring gear, so they caution against doing that. David Partridge also got great results ...very low

Magnus, The brass worm is really only needed on the RA, but having it on both axes gives you a spare, if ever needed. Getting the adjustment correct for the stock system goes a long way for

Hi! There has been tons of discussions on worm gears, but as I see more about OPW vs Ovision. My G11 apparently has the older stainless steel worms, so an upgrade is imminent. However, at least at

Lucky discovery. To lose 3 units at once... a nightmare. You might want to also pull out the Gemini1 board from each unit, and examine the top and bottom for corrosion that could cause shorter

Apparently so! here's the pic again https://www.dropbox.com/s/nduithn38oa0p6f/pempro%20pe%20frequency%20g11gt%2011-17.jpg?dl=0

I have an MI-250 set up in my side yard with the Gem I system. It's been happy there for the past several years, under my Telegizmos 365 cover, needing a new internal battery about once a year. The

Boy, I was going crazy as all three of my Gem I controllers were going crazy with the same gibberish at start up within a couple of weeks of each other. One was left outside undercover and had water

brian, Did you attach a photo that did not come through? aruckle

Hi aruckle, There is some discussion over at PemPro forums on this. My G11GT PE looks like this Thanks Brian Brian Valente Brianvalentephotography.com Sent: Tuesday, November

Brian, I noticed your comment about having a 42 second recurring error on your G11GT. A couple of weeks ago I bought the Losmandy RA-AXIS Titan module as an update to my G11. I have been

well i only mentioned it in pretty much all of my posts ;) I believe the source is in the tucked in gearing. As Ray mentioned he's working (finishing?) on a two worm cycle PE correction, which

Hi John yes they have the tucked in motor upgrade. I don't know if they only do RA or both, but it's a nice upgrade. give them a ring about this B

Sorry in advance for a question that I'm sure has been asked and answered: Until now I've more or less ignored all the talk about the G-11 upgrades since mine has been functioning very well. But I

ok. you win. I never saw that written...til now. Thanks for explaining this new design. I'll stay out of this, and will look forward to hearing the cause and cure of the "42 sec" PE