开云体育

have you tried using the guiding assistant? That should give you a lot of good input and recommendations B

PHD2 does complain about that when I am drifting... something about maximum pulse duration being too short, no matter how large a value I put in. g

Sounds like it could just be DEC backlash. Have you tried measuring that with something like PHD2? B

Code wheel is undamaged and clean (it's a US Digital one not an Avago (Broadcom) one). The sensor inside the unit is definitely a HEDS-9100 which I've ordered a replacement for. Dave

Dave, You might also try Mall-IC dot com and ask for a single unit price. Mark C.

Dave, That part number is obsolete it seems, looking at DigiKey. It appears the HEDS-9100 series is the appropriate replacement for the electronic module but check the data sheet at DigiKey for pinout

This is backlash in the meshing of the DEC worm and spur gears. It can be minimized by decreasing the spacing between the two (look for procedures in past posts of this group, which depends on your

Greg, What happens when you continue moving in the unresponsive direction? Does it start to move smoothly after the big jump, or does it stall again and then make another big jump? You should pull off

Hi Greg, It is important to take the cover off the (DEC here) worm and then rotate (rock) your scope back and forth around the DEC axis gently. Look for worm side to side movement. Sidecar side worm

I just removed the encoder part from inside the US Digital unit (E2-256-079 in this case). It is a standard Avago/Broadcom HEDS-9100 used with a US digital encoder wheel. The whole unit is compatible

I have been using my GM8 for about six months now. Have had the clutches apart and cleaned lube off the surfaces,got the enhanced knobs... rebuilt the pointing model a few times. All good. And yes, it

I have an RA motor from a G1 which I was asked to fix. It has dead shaft encoder. Does anyone know where I can get them? Thanks Dave Partridge

Thanks for the detailed explanation!

I have no trouble with this system for Stellarium : Download the separate program Stellarium-scope from Dragon-Welch computing. See what version of Stellarium that will support. Download that version

I’ve had good luck with Sky Safari connecting. Can’t speak to Stellarium Thanks Brian Brian Valente Brianvalentephotography.com Sent: Thursday, August 24, 2017 12:36 PM To:

Seeking advice of G11 Gemini 1 users with experience, good or bad, with Stellarium or Sky Safari Pro. When I attempt to connect to Stellarium, the software is either unresponsive or freezes and

Gosh, Rob! I have had the same experience as you have... load a "known good model" and ... very weird... the mount will slew to point my scope to the floor while I wonder what button to push to stop

Michael, thanks for your reply. As you said there may be issues in connecting to a PC, I thought I would describe the way I am currently building a model after doing a cold restart. I launch Gemini.

Hi. This,hapoens,can means your T pointing model is messed up. It happens because of the way the Gemini extracts the model parameters in sequence. It seems it cannot do a multidimensional least

Hi Tom. Yes I know these groups have no affiliation with Losmandy, poor word choice of "customer" in my last post implied that. Keith ---In Losmandy_users@..., <tomh@...> wrote : Keith