开云体育

midniterider@... wrote:

If the ST8 is like the ST4 you could do what I do. I use a simple 6 wire telephone "Y" splitter. Bought it at Radio Shack. I think Scott sells them too. Pete

Thanks, Bruce. I'll try changing the encoder resolution to 4096 and give it another shot. Let's hope for less humidity sometime soon! **** Ray

Hi,

Ray: Seems you had the same seeing in Chapel Hill as I did in Rocky Mount. :-) You are correct in polar aligning, then using the one-star alignment. You are also correct in pressing same button

Greetings all, I finally got a clear night last night to take the G-11 I'm considering buying outside for the first time. The dew was terrible (couldn't even keep my glasses clear) but I was able to

setting normal Mark: Your numbers just don't sound right. I'm no expert, but it seems that it should be binary. In other words, for every bit position, the number should double. For

For whatever reason, I don't seem to be able to fabricate a duplex 6 pin box for the hand controller and the ST-8 TIC cable to operate from. I am using a 6 pin RJ25 duplex box and have it wire as the

Greg, Glad to have been of help. Don

Donald, You're the man. I am running with excellent targeting as a result of YOUR help. Thanks for input Don, take care. Gregory david Stempel FIREFRAME

Don, Thanks for enlightening me. I was not aware of this difference. Greg

Greg, Mark specifically said he had 2160 encoders. The Losmandy supplied encoders are normally 2048 which when doubled by the gear ratio will require a 4096 setting. Mark is using used encoders and

Just wanted to say thanks to all of you for your input regarding my encoder problem. It appears that the correct encoder resolution setting is 4320. Apparently the encoders I have are 2160 instead of

Does Mark: Polar align the mount, then use the one-star alignment method. The two-star and 90 degree are for innaccurate or poorly aligned mount. After choosing one-star alignment, merely

Ya have to have patience, and it will all fit. I did have to file off a small amount of circuit board around the screw holes, and then carefully fit everything together. It does fit, patience is whats

4320? When I received my Losmandy DSCs, my dealer advised that they should be set to 4096. Greg Crawford

Doug, Herm, and List: Is there a secret to installing the aluminum motor covers? I just got a pair for my G-11 and the method "implied" by the hardware (there were no instructions) is use of

Mark, If you are using the Losmandy gear set you need to set the encoder resolution at 4320 because Losmandy uses a 2:1 gear ratio. Try that number and see what happens. Don

Mark, Here is what I did to determine exact encoder res. Remove your weights and the bar that holds them. Remove the OTA as well. Balance the mount with the bubble levels, then use a small bubble

oops! (g)...lets see what happens. "Doug Culbertson" <dculber403@...> wrote: Herm Astropics http://home.att.net/~hermperez