开云体育

Hello group, It boots normally, then it says RA motor stalled, or DEC motor stalled. Then the DEC axis slowly rotates by itself, no buttons pressed. Hand controlls have no effect. Time & date set

On Mon, Apr 21, 2025 at 08:23 AM, <avishekaiyar@...> wrote: > > Hi Jonathan, > > Yeah....PhD2 defaults to multi star guiding...or at least in my version. > > I attempted calibration last night

Hi Jonathan, Yeah....PhD2 defaults to multi star guiding...or at least in my version. I attempted calibration last night and made progress (I was fumbling with setting up the calibration run the last

I don’t think using multi star guiding would be an issue. The drive is only recording the corrections received from PHD2. How PHD2 calculates those corrections would not impact what the mount

Hi Jonathan This is indeed super helpful. If I get time tonight I will attempt it. I was actually going to use multi star guiding ..I am assuming that is perfectly fine but wanted to confirm since the

Hi Avi, it’s been a while since I last used my digital drive so procedures are a bit fuzzy in my memory but, here’s what I’d suggest. The 492 drive has an internal feature to save and use a PEC

Hello All I wanted to refresh this thread instead of starting a new one for a somewhat related question of my own. I am a recent entrant into AP and have a Losmandy GM8 and CG11, both with 492 digital

Good reminder, this is something people forget about 80% of the time then post wondering how it somehow has reverted back. -- Chip Louie Chief Daydreamer Imagination Hardware Astrospheric Forecast -

David Yes that way should work fine but I usually use the web interface to make that change.??I recommend using UTC but some apps will reset your time.? ASIAIR does something phoney like that and

Yes , set time zone = 0 https://gemini-2.com/hc/E023A.html Enter UTC and your local date, you are now sweet. ?Don’t forget to press “set” cheers -- Brendan

Looking to change my setups over to UTC time. Now do I just change over the time zone in the hand controller and the Gemini settings to 00? This made the current time listed as the UTC time.? Also,

I did get mine working. This video really helped. You have to pay attention to the mount limits in the Gemini and how they relate to the settings for meridian flips in the ASIAir. Getting Started 07:

Hi Chip, of course I've already sent an e-mail to Losmandy, but haven't heard back from them yet. Not sure if they really got my mail, since I received two automatic mails. One from the mailer daemon

Hi Andre, Based on that video how unlikely the bearings are to be contaminated given their location is irrelevant at this point.? IME a noisy bearing is a bad bearing and the fact of the matter is

I'm still having the same issue, have not figured out a solution. Mine starts the flip, I hear the RA and DEC motors start to spin up, and then they stop. I've only been able to make it happen

Hi Andre, Good luck with your efforts. So far no one has reported replacing this bearing in the last seven or so years I've been on this forum, so there is not much further advice we could offer. I

Hi John, the shield on the bearing looks like it's the crimped on type. Opening would probably bend the shield. So I guess for the time being, I'll leave it as is, since it's not stuck or anything and

Hi Andre, It seems unlikely your main bearing inside the Dec ring gear could have gone bad inside such a short use period of only a few years. There is often some play in bearings when there is no

Mitsumi has 5 models of 6010ZZ (ZZ denotes non contact/shielded type). Models differ by load strength, quality, etc. They should have German distributor.

Hey Chip, thanks for your explanations! Ordering parts from Losmandy directly is a bit of a hassle from Germany. Shipping is quite expensive compared to the cost of the parts and dealing with the