开云体育

I understand this, but there is a gray area I am in here, a cause and effect inversion of sorts. I was surprised this happened because I adjust my spring frequently, just for practice's sake. I even

FWIW, I would caution against increasing voltage to solve a stall that is accompanied by a warm motor. A higher voltage may help the motor overpower excessive friction or imbalance, but will also put

Hi Mark, thanks for the thoughtful response. I understand all that you have said. I am an electrician with a degree in electronics, so I understand quite a bit about the subject. I have read here that

VictoryPete: With the greatest respect, most people overtighten their worm mesh in my experience in an attempt to totally eliminate backlash. This happens even more often with DEC. In addition, worm

I’m a new G11G owner; new to the Losmandy Universe. The first few times I had my Win10 machine connect to the Gemini, no problem. Then for the next 2 or 3 attempts I had the same issue you describe.

Russ, this has nothing to do with update, but a setting you've changed in the ASCOM driver. Is this the message you're talking about? This is asked when you turn on the update advanced settings from

Are you talking about the "Set Gemini Time on Connect" or "Set Gemini Site on connect on the ASCOM "Configure Telescope" page? Or the "Send Advanced Settings to Gemini on Connect" box on the ASCOM

Ever since my upgrade, I've been getting this message about uploading PC data to Gemini.? I accidentally selected ok tonight and now it is updating slowly (about 10 minutes) elapsed so far and not

Apparently, it was tracking with intermittent RA Stalling. I thought an RA Stall stops the motors. I had adjusted the worm gear a few days ago so I am surprised it tightened up so soon.

It is a DC Servo motor. They get warm under use. This is typical of all DC servo motors. Generally speaking a servo motor will not be damaged unless internal temperature is higher than 130C and outer

Is a warm RA motor normal. I have never noticed this before. I have a 10 month old G11G.

Thanks!!!! david.partridge@...> wrote:

I did get about an hour of messing around again last night before some unexpected clouds came in.? I was able to adjust the guide settings in the ASI air and get the RMS down from about 2 to about

I have sent the firmware images to Christopher David Sent: 25 February 2024 04:54 To: [email protected] Subject: [Losmandy_users_io] Dual-axis controllers EPROM images Would anyone

Loren, Are you saying the target in the eyepiece is oscillating back and forth as you look through it, or just a

Would anyone here happen to have copies of the firmware binary or hex code for the EPROM's for the Losmandy dual-axis controllers? Also it is my understanding that the EPROM code for the GM-8

Check the two Azimuth bolts and the Altitude bolt on the mount.. They may have been loose when you received the mount assuming you would tighten them when you polar align.. And make sure the scope is

Hey there Loren, That does help me understand a bit more; thank you. My only additional question: Have you tried adjusting the worm block position to fit snugly on either side of the worm gear yet?

Ryan The term "springy oscillation" describes what I see when mainly centering the scope for visual use i.e. repetitive image movement with a period of maybe less than 1/2 second. I've observed

Hey Loren I’m looking for further clarification if the term “springy oscillations” For perspective, it is difficult to troubleshoot a system with verbal descriptions that don’t match a