开云体育

Thanks to you both.? Very informative. At some point I will give it a shot.... you are making it sound fairly easy.? When I do it.... I'll have both the scope/imaging equipment and the

An issue that has never been mentioned on this Gemini forum is electrical circuit noise inhibiting the normal processing of Firmware commands. ?Barring the obvious bad cable/connector/battery/dirty

Dan I have the same scope mounted. The worms come off regardless of if the scope is mounted or not. Remove the 14mm nuts first. Then you unscrew the top mounting worm back off bolts. Those thread into

Hi Michael. The fail was in all positions, always doing a GoTo command or a Park command. Every command that use 2 axis will fail after 1 sec of start or less. Is like instantaneously. Manual move of

Absolutely! Don't even think of leaving the scope on while removing the worm block -- the OTA will spin freely if you do, with nothing but the hard tripod to stop it. Not sure. Once you remove the

Very special skill, tools and techniques are required to remove a large scale chip on a multi-layer circuit board and if the board traces are damaged there will be new problems to solve. A more like

Thanks, guys. Paul: Your write-up on adjusting the worm mesh is basically what I was doing with those bolts.... a tad of torque on the wing bolts, and I get the noise.? Back off just a little, but

I certainly can see the benefits of monitoring current and volts for the Gemini -- Brendan

OK, what weight amount should I use? Do you do a final balance after adding that weight? Aubrey Sent from Mail for Windows 10 Sent: Sunday, May 9, 2021 9:54 PM To: [email protected] Subject:

Dan, The lube on the Titan ring gear needs to reduce the worm friction to as low as possible. My research on the "4-ball test" and the " Timken load" test shows the "CRC Brake and Caliper Grease" has

Hi gang, As a simple temendy for Enol, just reduce the maximum slew rate. There is a digital setting for that. If Enol's system runs out of current as the counterweight shaft moves toward horizontal,

Yeah peak is a bit overrated mostly why’d 200-250ma (if not less) at sidereal rate to 600ma slew but take into account both axes at this does so 1.2A peak. ?It’s hard to tell with digital

Just to add a data point.... I run my mount, two cameras and mini-PC all from the same 12V 5A power supply. I do not recall individual current draws but with everything running (and the imaging camera

Brendan, one question. The manual of the G11 says you need at least 3 Amps to work propertly. I think this is for GoTo commands to work. With your information, a GoTo only need 0.35 Amps at 17v, so

Hi Dan, Glad to hear you're making progress with backlash! The sound appears to be caused by too tight of a mesh between the worm and the worm-wheel. Very tiny variations in worm and wheel can lead to

Paul: Last night I cranked up TVC in G2.... up to 100.? Ran the GA, and I couldn't believe it, there was no backlash shown on the graph, in fact the actual plot was very close to and slightly left of

Enol Lm2587 (

Hi, I'm interested, but shipping and taxes probably will cost more than the box itself. El you have a wiring and component diagram to made one? Greetings, Enol. El lun., 10 may. 2021 3:44 a. m.,

Aubrey, that is the great benefit of the hanging RA cord. Hanging the cord and weight off to the East experimentally gives the lowest vibration (chatter) to the RA ring gear (worm wheel) as it is

Thanks Michael, but its not clear how this works on both sides of the meridian. I am also operating remotely so everything has to work without dragging, snags etc. Aubrey Sent from Mail for Windows 10