开云体育

Ken...we have no buy and sell section and probably won't ever be due to possibility of fraud and bad transactions.? I mean I'm not the site owner but have been around long enough to guess....Yes the

Thanks for all the info guys, both of the above pics show that what I was thinking about won't work so definitely need a rethink :) Atb Pete

Hello Losmandy Users, I own a GM-8 That is about 13 years old.? I have it advertised on Astromart right now for $700.? It was purchased before Gemini 2. It has been sitting in a bedroom closet for 4

Ah good pount It depends on which part you're sitting talking about If it's the tripod without the mount connector that's open like Michael said But you do need the connector part on to of it to mount

My tripods are open at the bottom. There are 3 large diameter leg tubes that are welded to a larger diameter vertical tube. When I get home, I'll photograph it and send you a picture and get the tube

OK thanks, will have to have a rethink of my project then :)

HI pete If you mean where the G11 mount drops into the legs, it’s closed on mine. Pretty sure it’s closed in general Thanks Brian portfolio https://www.brianvalentephotography.com/ Sent: Tuesday,

Hi, The underside of the G11 tripod head (the older fixed leg version) between the legs, is it open or closed? Thanks Pete

Hi Michael, Yes, using two Bellevue discs was very tight with the 2-piece bearing blocks, I had to squeeze and push harder to get the backlash right. A difference may have been in how we created the

My calibrations are always awful, and from seeing how many folks bring that up here, endemic to this mount and/or PHD2 and this mount combined. I may recheck/reset the calibration step stuff, but I

Thanks Anthony I don’t know how much (or if at all) you are looking for feedback on the guiding, but a couple observations: Pretty choppy night, you might consider increasing your exposure to 3

Guide logs from last night's imaging session, (Iris Nebula)... https://openphdguiding.org/logs/dl/PHD2_logs_DrYG.zip If I take out the sections where I was refocusing, I get around .78" RMS. I'll take

Sorry Chip for my error. I also tried two Belleville washers small end to small end, but there was barely room in an OPW for that, so I don't recommend that. The force remains 7 pounds max but the

Joe, The video you attached shows your Oldham coupler gap is too large and possibly the retaining grub screws are loose based on the clicking noise and obvious gaps shown. There should be no obvious

Hi Michael, No, you misunderstood my post. The Bellevue discs used singly or in pairs requires that the large end of the spring disc presses against the outer bearing shell, not -[](- against the

8" at 1457mm. It was a good night! Consistent except for occasional turbulence. I'll post PHD2 logs later. Now to shoot darks...

I'd be interested to see your guidelogs when you finish this session. I recall you are shooting a 12" or 14" ota? wrote: -- Brian Brian Valente portfolio brianvalentephotography.com

Decent seeing tonight, but the PEC and mechanical stuff is playing into this:

Joe you covered a lot of ground there my friend. i definitely get you're frustrated and it sucks to spend a lot of time on a hobby that is just endless frustration I think if you look back on our

No-one here works for HGM (Scott’s company) nor do we have any means to influence him. Are you anywhere near Michael Herman? I’ve sure there’s a good chance he could adjust that for you. David.