开云体育

I have ordered the Scope Roller 70: 100mm AlPu? for astrophoto Thanks for all help.

What I do with the G11 is mimic what the DEC motor cable does by routing the camera cables (power and USB) between the clamp knobs, contained with a silicone band around both knobs. I use a fairly

This is for tucked-in motor adjustment, but similar adjustment would apply to the older motors, mounted on the outside: https://youtu.be/Vqqjz40qAu4?feature=shared Check out other videos on how to

You may want to contact Losmandy about parts for the non-tucked motor design. My tucked motor G11G2 has two outer spur gears under a black oval cover, and the gearboxes go between motor and bottom

It could be the gearboxes. I believe Losmandy refers to these as the Spur Gears, but I could be wrong. The two gears under the oval covers for both RA and DEC.

First thought is that your drive motor(s) have loosened up and are not meshing tightly. If you loosen the 2 screws and then try to turn the motor CW or CCW and see which makes the sound less, then

I don't really use the HC much other than to set safety limits and manually slew around after I adjust the worm gear. During the last few days I've been using it more often for those purposes and I

Gary, Are you sure it isn't the motor gearboxes? Mark C

Bought my G11 with Gemini 2 new in 2017. I has worked perfectly for all these years with not much maintenance. It does not have the tucked in motors. I just recently noticed it is getting a bit noisy

The casters look to be the same model used on HF's dollies designed to support a vehicle's weight at each tire which I've used. HF has a pretty large selection of casters. I like the kick down lever

Mike, I agree with most of what you are saying. I particularly agree that the Anderson Powerpoles have a lot of advantages, they are solid, make a good connection and a solid contact, have good power

I haven't hiked it, but have driven to the top of Mauna Kea.? Fire is probably not a big concern, except for the effect on seeing if a large fire, or volcanic eruption were to occur with winds

I've observed the same behavior with my g11g. I took it (mount RA head and mini) in for the software and firmware upgrade and asked Scott to check the SLW. He re-adjusted it and same behavior. I found

I use these under many of my shop tools like table saws and band saws. The wheels are most likely too small for traversing gravel, dirt or grass but the concept is simple and buying one of these to

In a better world . . . I’m wintering in Baja far from my scopes and have run out of new places to explore on my dirt bike thus I’m reduced to browsing through the 80,000+ messages on here.

I received email from Mr Nugent this AM.? Very good. I worked for 4 startups in Silicon Valley in 80s-90s timeframe.? All went belly up.? I'm still poor. :(

Here is one more video that shows the actual worm BLOCK adjustment: Here ( https://www.youtube.com/watch?v=LmcEYhat7jE&list=PLeM-apAbabi3fDW_qj93eHmrKFDfhRjfn&index=1 ) Sorry, this is the one I

Hey Ryan, Ryan here. I've been where you are. I wrote this post to explain my approach to the spring loaded worm adjustment: SLW Worm Block Adjustment (

And to further clarify. I have a good PA within 30 arcsec of error. Seeing is not the issue as this is consistent across every night.

I sent my mount in within the past 6 months to get the L6 upgrade, ra/dec extension, and springloaded worm addong. I started noticing after this it is taking forever to get calibration and after