开云体育

Probably a Chinese copy. Fine them handy for thing I use a lot. Keep electronics parts and assemblies in this Harbor Freight rack and a couple of plastic multi-drawer storage units on top. [image:

Apologies for not replying with my thanks earlier - my email was filtering lots of my groups.io to junk for a bit. So thank yo all for the help and suggestions. I have been mulling over which path to

I have used my G11 these past twenty years on a variety of different tripods.? The standard G11 tripod it came with is excellent.? The Berlebach wood tripod is easier to handle in snow. Less known

Oberon510’s picture shows the hand knobs at the top of extension and hex bolts on the adaptor. You can also switch these bolts so that extension stays attached to the RA rather than tripod/pier when

Thanks, John. I removed the RA axis cover and did not see anything amiss when slewing. It looked pretty perfect. I fiddled with the SLW. The sound is much fainter now. I don't think it is now

Hi Joe, I'm not familiar with AstroArt, so these comments are based on some assumptions. A few things worth noting: There are two different and distinct methods of autoguiding Gemini, and you need to

I appreciate all the replies and the pictures. It helped quite a bit. I ordered the 12" extension. Thanks, Joel

Hi Joel, Some pics of my pier attached. Below the rat-cage, I have a 4" OD solid aluminum cylinder bolted to one side of railroad track cemented into the ground, and another 2x3" aluminum bar on the

Joe, I’m not great on things like guiding but I do know I have read of issues with this very same camera QHY5ver2 Search all the the Gemini forums. Here’s one to start with.

Hello All. I have an issue with Astroart 8 and my G11 Gemini 1, specifically AA8 calibrating commands not getting to the mount, or that’s what it seems like anyway. I have a QHY5Lii guide camera

Hi George, A ticking while slewing does not necessarily mean a problem with tracking and guiding. Since you are in slew speed, it's hard to say where a 0.5s noise might be coming from. You may want to

I have a G11G and the DEC was making a clicking sound when slewing under load.? I used one of these to isolate the sound.? The SLW needed adjusting.

I just received a new Titan axis upgrade for the Losmandy G11. It is a beautiful piece of kit. After balancing the axes and selecting the G11T in the hand controller, I moved the mount on both axes to

Interesting you're dissatisfied with the 858D. I too have one of those plus additional nozzle. Don't use it for anything really sophisticated but find it quite well suited for the occasional job of

“Yeah and clean, well ? ? ? ? organized workplace.” Hahaha I start every job with a clear desk …..end up looking like that. ?Only takes a few hrs! George, you use “Dexion storage bins”!

Joel, I did this same thing several years ago. I pulled the MAL adapter head off the tripod and bolted it to the top of my pier with the center bolt hole. However, I did use a rat-cage with two

Yes? - same as the top of the extension that secures the mount - https://store-losmandy-com.3dcartstores.com/ex-12

How did you get a photo of my desk???

Yeah and clean, well organized workplace. [image: image.png]

Well the UART jack is a RJ-45/12 with 8 conductor connections. Minium UART requires TX, RX and ground connections. You need to know which connector on the plug gets which signal. Here's the pin outs.