开云体育

I will try a larger east bias, does anyone have a way to quantify this? *** I know of two ways.. My way is to balance my roughly 25# load to "balance".. Then I move the weights - with the CW shaft

Nick, I recently tied a 7 lbs cast iron pulley to a heavy clothesline cord and wrapped the cord around my RA axis so the weight hangs to the East. See pictures. That, and backing off my RA worm

Hi Michael, this is a pre-OPW mount. Any chance you can pass along your number? I'm on the east coast and can give you a call. It would be easier to explain the issue that way.

I have that mount and successfully upgraded it. I used the original long OPW (no longer in production), replaced the old steel worm on RA with a new brass one, added an R4 Belleville spring washer to

I have some very specific questions for someone familiar with the early G11/CG11 mounts? DEC axis assembly.? Anyone out there before I continue with the details? Thanks Tom

Thank you all, I was able to update the firmware and reinstall drivers for the asi120mm. I also ordered a new cable as it seems to be a common problem. Last night I was able to connect the camera and

Nick, I have seen the same trouble with the same ASI120 USB2 camera. It is not the mount, only the camera. I think the problem is with the driver. Look on the ZWO website for a new Win10 driver. It

Nick.. You wrote.. I know the mount isnt perfect but seems like PHD2 should be able to guide it a little better, something just isnt clicking *** And Brian wrote (and I've stopped looking past the

Gracias Brian ?

Hello David The G11 uses the MA adapter https://store-losmandy-com.3dcartstores.com/ma The G11T uses the larger diameter MAL adapter https://store-losmandy-com.3dcartstores.com/mal I hope this answers

Hola grupo !. Tengo en el muelle permanente un adaptador para g11, mi duda es si el adaptador para la montura g11t tiene la misma distribución de agujeros o deberia mecanizar la base del muelle ?.

Alex, I will provide them for $6 each plus the postage. The trick to turn them without excessive tool wear is to replace the grub screws with some short enough to keep clear of the tooling. I find M4

Geoff, For reference, you might find the polar scope description on pages 12-14 of this manual helpful.

Curious if anyone has input on this, article below. I have this same asi120mm usb2.0 "puck" version it's older, not the USB 3.0 or mini. I have similar weirdness, one example, when centering a star,

*Adjusting the Polar Alignment Reticle with Polar Scope Align Pro* I have been working on fine tuning my PA process with the Losmandy Polar Scope and am using Polar Scope Align Pro with the Kenko

I have a newer G11G, up here in Michigan and was getting a lot of DEC stall warnings as the temperature got down in the single digits. I was able to stop them that night by increasing the stall

No, your hacksaw wouldn't cut hardened bolts. But you can cut them with a cut-off wheel, or grind away the excess with a grinding wheel. The bolt is going to get real/red hot. so quench often and go

Hi John - I am looking for a DEC extension.

Jim, Not sure if you are just talking about an RA extension. I pulled these pieces out of my G11 when I put in the break-apart RA EXT kit. I am sure HGM still sells these. They are 4 7/8 in. in

Hi Brian, Yea that's how I view the logs, tonight started clear but after an hour or so I would get an occasional cloud drifting through the FOV. A clearer night would be nice but it still seems like