Try to clear out and reset any model that you may have in Gemini, cold start, or even fully reset Gemini to make sure.
Regards,
? ? ?-Paul
toggle quoted message
Show quoted text
On Thu, Jul 22, 2021 at 07:59 AM, <pcboreland@...> wrote:
Paul,
I've found a boundary condition were my meridian flip fails. The scope stays on the west side and ends up pointing at the ground. Any thoughts by folks in the group would be appreciated. I do not know if this is a settings problem or a bug someplace??
?
If I slew to a coordinate that is say?Ra 1h 59m 59s,?Dec 32d 35m 13s, everything is fine and Gemini controller reports the position on the controller interface and shows the target in Cartes de Ceil after the slew.
?
If I then slew a faction amount to?Ra 2h 00m 00s, Dec 32d 35m 13s Gemini suddenly reports the Ra as 15h 00m 00s and the target in Cartes de Ceil appears in the southern hemisphere. There is a sudden jump in position reporting, but the scope does remaining pointing at the correct position in the sky.
?
But if a slew was initiated as for a meridian flip, the scope would end up pointing into the ground. I do not know if this is a problem with the driver, Gemini or my Cartes de Ceil settings.
Peter
Paul Kanevsky