Re: Building a Digital Mode Data Interface Cable
|
Great work! Clean and neat. I too am interested in that box. Can you please provide the link?
de Steve W0ARK
On Tue, May 11, 2021, 12:48 PM Henry Pollock - K4TMC < kilo4tmc@...> wrote: Glen,
Thanks for the pictures.? Can you provide the link to that aluminum box?? I need it for another project.
73, Henry - K4TMC
On Tue, May 11, 2021 at 2:40 PM Glen Jenkins WB4KTF < wb4ktf@...> wrote: Hi all,
I just built an Interface cable for the Audio Data Cable and included amplifier keying.? The amp is a MX-P50A with manual band switching (gives about 40W output).
This interface is all built inside a 1"x1"x2" long aluminum enclosure that I got on Amazon.
I used a 4 conductor shielded audio cable and also installed 6 ferrite beads inside the visible heat shrink tubing near to the GX-12 connector.
The 10uF capacitor is inside the small enclosure.
I did use three stereo audio jacks instead of plugs (also from Amazon).
I attach two photos for your information.
Glen - WB4KTF, Austin, TX USA
|
