开云体育

I have watched both videos on the aprs set up for digipeater.? Of the two the baofeng was most valuable for the set up and programing steps for direwolf and xastir.? I note the list command revealed the audio codecs for the signal link kit with the baofeng.? However the set up for the ft2980 two cable are used.? One into the mic for pit and a speaker cable.? And the list command show the audio codec and a speaker port.? Question:? What is the direwolf code for the ft2980 setup?? ? For the Ports.....

point to the usb serial for your interface (digirig? ttyUSB0)

k

Tigertronics Signalink.? ? It says to always use audio codec.? When I list it is the third option via the ls method.? Have you use the? ft2980 and signal link?

The signal link keys a cm108 chip to trigger ptt via vox essentially?

so you will have no CAT classically as there is no serial in that device?

Aka no ports just sound card I/O so finding the cards number (arecord -l ) and putting it into direwolf

k

Kelly, CM108...I have read that as a packet to install for direwolf.? But I think it should come with direwolf.? I have a fresh install of bookworm 64 and Direwolf.? Right now searching for install instructions for Xastir and bookworm..? Most info is old and for older pi linux versions.? Hopefully when I plug in my Signalink this direwolf? will read it and give me a usable tnc/tty0 .I will have to set up direwolf.conf.? Then I can install Xastir and set it up and get going.??

This is definitely tougher than my IC-718/FLDIGI and FT857D/WSJT-X installs with the Signalink.

Installed and running now

2 channels for signalink

ADEVICE plughw:CARD=CODEC, DEV=0