开云体育

Chris ..... I have to get batteries for my chair as well ( there are two 55AH =) Which batteries did you use and do you use the battery charger that came with the chair ??? Thanks for your responce=)

Hello Joseph, I had an issue with my wifi when there was a space in the SSID. Seems like the Rpi wouldn't connect up. I do have other Rpi's at my house, but they are for non-ham things that don't use

GA all I don't have screencaps handy just now, but I can get them if needed. When I open Hotspot Tools and select "Managae SSIDs", I might have two networks saved, but there will be four lines. One of

Hey Terry, I don't know what size batteries you use in your chair. However I got rid of my 2 heavy as fun! And replaced with liposuction. My chair will actually travel about 3 miles further with less

I don’t have any experience doing this but I would think you could use a cheap SDR receiver dongle and software to look at the signal. You should be able to see how wide it is on the screen. Jeff

Yesterday I ordered a Digirig and Baofeng cable. I am running BAP What changes do I need to make to direwolf.conf to enable PTT in this configuration? thank you

Look at data over a scope. It must be pure sinewave then you know levels etc are 100%. Normaly at about 2.5khz deviation is good. Greetings from the Namib Pieter Jacobs +264811277615 NETS NTNSS

The only reason I posted was the price in Canadian dollars. There's a difference between Amazon.Com and Amazon.CA. 73 *Don PoapsNew Westminster, BC*VA7DGP DATA VA7QU VOICE *Winlink: va7qu@...

For 9600 Baud AX25, Yaesu recommends using a Deviation Meter to set the deviation. ?I get intermittent success with various sites and probably need to adjust my radio. Does anyone have an idea for an

Hey Don, I've picked up a couple of these on the US Amazon store:

Unless you changed the account name, it should be pi for username. Should also be your pi password. 73, KB5WCK ________________________________ Sent: Saturday, February 12, 2022 9:57:06 AM To:

I was able to ping the IP. I then was able to verify that VNC was enabled. Now I can’t remember what username and password combo to use when settiup the vnc connection. I should remember but this

Dave First I would recommend adding a blank text file - ssh.txt -? then using putty or what have you on windows or terminal on macs. ssh into the build a pi, run "sudo raspi-config" turn on? VNC

Another possible answer:? Sometimes when I boot my Pi it fails to recognize my Wifi so I have to wait until the Hospot timer tries again.? I set mine to 2 minutes.? Then it works as usual.? For

Most obvious question: Did you enable VNC in raspi-config, Interfaces, VNC? Kevin -- KD9EFV

Good evening All, Created my first Build A Pi SD card last night.? Added a bunch of Jason's tools, Winlink, Direwolf, Hamclock, Conky etc. I shut the Pi down last night, and returned this eveining

Jason, Something to note. The ARDOP PTT config is available in two locations in PAT Menu. One is in Manage PAt Winlink as you described before, the other is in Settings/Config. I had to make sure both

Just tried a few digferent resolutions again and its always the same with the js8 program. All the features are too large and wont match its window size like the terminal window. Terminal woll adjust

It seems like things like terminal frame are fine with me, just the js8 program.

I'm having the same issue. My PI 3 A+ is nicely set up for my desktop or Toughbook. I tried to change the resolution on the pad and it was a lost cause. I may have to get an Android phone terminal and