Ok, I have a Pi 8GB, but some how I over powered it and saw smoke
come out, so I
will putting in an order for another. I was going to set it up to
use as the home PC
with two monitors to replace the old laptop I am currently using.
I have the adapter to
use the 500GB internal drive of the laptop here now, and a
monitor to mount the pi onto
and another monitor to plug in. Looks like I may have to just put
in an order and wait until
they ship to me.
The Rpi 4B 4GB that is the Ham PC is doing good. I have it loaded
with the bullseye 32 and trying
it out. However with the shack in the garage and no heater and
temperatures running in low 30s
I haven't gotten to try it much. It did install the three
Fl-suite apps I use just fine and the few others
too.
Have a good day.
Marty kd8bj
On 2/6/22 15:21, Curt - KC9CTP wrote:
toggle quoted message
Show quoted text
On Sun, Feb 6, 2022 at 02:24 PM, Marty Hartwell wrote:
Hi Curt
I don't remember is you said in the first of these emails,
but what Rpi are you using this on? If it is one
with less then 4GB you will have to extent the size of the
swap space. I have seen FlDIGI fail to install
at times even with a pi with 4GB, so have increased the
swap to one or two Gigs to allow it to install.
You may want to try that.
I have never had a problem? with a Pi with 8GB.
?
Marty kd8bj
toggle quoted
message
Hi Marty,
My test Pi is a model 4B with 8gigs.?
It just rips through the install pretty quick. The 64bit Bullseye
installs BAP quicker than the 32bit Bullseye.
Curt
