¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io

Re: Winlink Gateway -> DINAH and Direwolf


 

I have a Master Communication DRA 36 and I'm running on Hamvoip. I had to switch a pin to make it work on the Allstar node I have from regular soundcard?use.

I never tried it on Build a Pi. I do know in Winlink Express I used UZ7HO. I had to download PTT.DLL.zip from the UZ7HO web page so UZ7HO PTT the radio.

I imagine that in Build a PI Flrig?is Ptting?the radio and if you point pnp codec of C media chip it should work.?

Good Luck

73
Don Poaps
New Westminster, BC
VA7DGP DATA
VA7QU ? VOICE


Winlink: va7qu@...
Subject://wl2k ? ?
? ? ?

ALLSTAR ?530780
Hamshack Hotline
5971
Mid-Island Phone Mesh
2210
2232

? ? ? ? ? ? ? ? ? ?


On Tue, Jan 18, 2022 at 8:47 PM tomsdad97 <sharpst@...> wrote:
G¡¯day Jason (and the group)!
?
I¡¯ve been following BAP and your videos for a while and your video on the Winlink Gateway really caught my attention as it was something I¡¯ve been wanting to do for quite a while as there are not many gateways in VK and I wanted to change that.
?
Your video from December ¡°Winlink Gateway on a Raspberry Pi LinBPQ¡± was exactly what I was looking for, it went exactly as you depicted it, it is so nice when a project works out of the box so to speak!
?
My only issue is that I don¡¯t have a Signal Link (very expensive and difficult to source in Australia) so would like to use my DINAH interface () instead.
?
I¡¯ve read the docs, I get the impression that if I added ¡°PTT CM108¡± to direwolf.conf I should be ok.....
?
Sadly that did not work so I¡¯m throwing it out there seeking guidance from the experts on how to get the DINAH to transmit under Direwolf.
?
73 Steve VK2ARS

Join [email protected] to automatically receive all group messages.