开云体育

hi,

I saw that also BSS99 schematic is available any one know how to program it because there is 16mhz if I'm right?
Is there any arduino files?

br Jan

I think I understood what the problem was. Heavy snowfalls interfered with the operation of GPS

everything seems to be fine

That GPS antenna looks way to long, it should only be 46mm long.?

Hi.?I am using a 3.3 volt arduino stabilizer. the arduino board is connected to the USB. antenna - a guitar string, all this is in the open air outside the window

Hi, I have never seen this behavior under countless hours of testing and flying the firmware, first thing that strikes me is that the board might have lost gps sync, how are you testing it? maby put it outside on battery power and see if the problem is still there.

gps antenna? what are you using?

/Mikael

The first few hours the tracker works fine, then it starts transmitting every 2 minutes. I tried both original firmware and Mikael's firmware, no difference. This may be due to the fact that I use U-blox MAX-M8Q modules? Or is the problem something else? who faced such a problem?

Hi, that "Antenna Open" is ok, make sure pin 5 floats or/and that its not pulled low, any pics of the setup or schematic?

Yes, this will work fine with the ICT code/tracker and also most likely with the upcomming qrp-labs wspr board.

/Mikael

Mikal,

This will work with the ICT3 tracker??

Paul
KD4GUB

Hi, Good to se those files come to use :)? its my pcb design and take on the ict fw, the code is the most updated one and is likley working as good or better then W5KUB code, if Im correct they stil use original ict code which have a problem with wspr timing/encoding, I presented the new improved code for KUB in oct/nov they did not for the follow flights implemet it, though a bird wisperd they might have had help setting it up on later flights, as those files in my git using interupdriven timing of the tx it will at least be on par with best out there and its much simpler to build/assamble as it have less components to solder and is as light/small it can be and you have the option to use the small or large 328 ic.

A big tnx to Eduard YO3ICT, that helped me implement this new interupt timing into the code after I found the fix a couple of month ago!

Also tnx to?RAJlab at??where I found the timing code. Its compatible with the ict board as well with minor tweek of the code

73 and good luck!
/Mikael

Hi all,

Appreciate all the useful information which is shared here in this
group. We are going to fly the ICT v5 tracker based on the PCB designs
and code at - but, as I understand, new
W5KUB's are flying with newer code (and possibly updated versions of
the PCB).

Maybe you could suggest how to get the subscription to the picoballoon
group approved?

Thanks,

--
Simonas K.

Konstantin,
Thanks a lot!? Helpful to know.
--
Chuck / KG5CA
StratoCasters

I have checked the atgm module to 64km altitude with Hack RF and it tracks all the way up there, as Mikael said, without high altitude strings being sent to the gps.
Dave VE3KCL

I have been using the ATGM without issue, no setting needed to allow high altitude operation.

Hi Jan , the atgm gps module are plug and play, just remove all lines containing any gps strings in the code and it will work great! :)

/Mikael

?