开云体育

Hi Franck Here’s a few possibilities: 1: The RTC put in was probably 2nd hand or at worst “counterfeit”. ? The only sources of these can be good or …..dreadful! ? Sometimes it’s a

Hello all, I'm the proud new owner of an old G11? from 1995running Gemini 1. To get it working almost like new, I had to re-grease it, replace the polar scope, and decided to reduce the default

The connector IDC types (Insulation Displacement Contact) are for solid conductor and stranded conductor. One can find “flat” wire – easier to crimp - but I have had poor results with long

Gotta say if you are happy with the shorter cables you have. ? ?No “glitching” then keep what works for you cheers -- Brendan

You can buy flat single core of multi core RJ cable. ? Also a crimp tool and RJ45 terminal ends….crimp your own. ?Or try repairers to make them. Be aware some RJ45 connectors are for solid core

I agree. I would think a 15 foot long motor cable would be worst case, so getting 3 foot ones should be better. I have run the cat8 3 footers on the bench for 8~9 hours a day, and many days now w/o

Good call Paul, well done! Cheers -- Brendan

IME with Gemini 1 controllers you really need to replace the battery at least once a year even if you don't think so.? My advice is to ALWAYS have a small toolkit with a couple of spare coin cells in

Hi, i replaced the CR2032 battery and what shoud i say ? THANK YOU ALL FOR YOUR POSTS ! This was the reason for my gemini fault. After i replaced the battery, the mount runs perfect and everything

Just keep the battery out for a minute before replacing. That's needed for the capacitors to fully discharge, allowing all the settings to be completely wiped from memory resulting in a full reset.

Hi Guys, thanks a lot for your answers ! Later, i will replace the 2032 battery. I don't use the AG-port. I have an Starlight AO and only use the RS232 Port. But before i change the battery, i will

You've checked the cables already, this is good, since every little spurious signal that could be a button press (Deluxe or classical HC and AG) would be interpreted as an interruption of a Goto

Actually Paul is correct...check basics first...new battery re-input data and limits retry it...I guess you can emulate it during daytime to slew to stars that are above horizon during the

I have actually seen this before on my G1 a few times, many years ago. ? It went away, so, I thought it a firmware glitch. But it’s possible it’s not reading encoder pulses properly so keeps

Hi ?, I'd start by resetting Gemini completely by taking out the 3v battery for a minute or two, and then replacing it with a new, fresh one. **Interrupted** message usually indicates that Gemini

Hello guys, my Gemini System runs about 24 years without a greater problem. But now, i have a problem with this system. If i want to slew to an object, the system make a slew, goes into centering

Everything looks in good Nick polar scope,CKS clutch knobs and the 127 looks good yes older motors but they look in good nick -- Brendan

Thank you for the links. In Photos, I just created the folder "Tom Losmandy G11 Photos" and within this folder are the two seller provided photos. The motors appear to be old discontinued standard

Tom you’re good, Paul answered better than I could. ?He’s a wealth of knowledge. Take pics ….we can analyse them. Check axes are smooth and clutches engage but allow slip. ?Try to skim the G1

Thanks for the help. Cross posted - I was not sure if my post got through here, being a 10 minute old user. Regards Tom