开云体育

The first thing to check is that your Gemini settings are still correct. For example, HC mode should be Photo or All-Speeds, otherwise no guiding will happen. Then, check that you have the correct

Thanks Paul, The PHD2 autoguiding was working near perfectly until this happened.? I had just finished over of hour of imaging a planetary.? When I wrote that RA guiding was a problem, to be clear,

James, Limits!? Also look for hidden damage.? The servo motor fasteners often damage the gearbox threads and the backing plates of the original G11/GM8 mounts were heat riveted and tended to break

You just have not been around long enough. The Losmandy #492 Digital Drive is not a spin off or copy. They were the original Losmandy #492 non-GOTO Digital Drive controller systems and used a gear

Hi James, did you try to run PHD2 guide calibration? That should tell you if the mount is responding to guide commands, and how well. Regards, -Paul

Hi, A bit of background first:? ?I have a very old, but faithful, Losmandy G11.? I upgraded to Gemini 2 about a year ago.? Last night I had been successfully autoguiding with PHD2 for a few hours.

The twisting of Ethernet patch cables differs from what Gemini needs. There could be spurious encoder ticks induced by PWM pulses if motor wires and encoder wires are paired. Not sure about cat8

Wow, I have not seen that controller before, I but it looks like a spin-off of the ci700 controller, and the G11 looks pretty similar to the ci700.? ?:)

I recently fixed my 2nd Gemini1. The flat motor cables were intermittent. I made some cat5e cables 2.5' long and it seemed to work but I let it run on my bench for an hour and noticed the PWM signal

Doesn't work with G1. Support for Solar System objects through the serial protocol was added in G2.

I’m using a G1 right now… Does that catalog get pulled from a G1? D. Sent: 03 October 2024 13:45 To: [email protected] Subject: Re: [Gemini_users_io] GeminiTelescope Solar System catalog

David, the same problem with Gemini not being connected. The driver loads all the catalogs only once, the first time you go into the manage catalogs page. If you're not connected to Gemini, it will

If I open the Object Catalog manager and select the Solar System catalog, no objects are shown.? This is true in 1.1.25 and 1.1.28 Should be easy to fix I expect. David

This has always been the case (don't ask me why!) -- but to change site information, you must first enable 'Set Gemini Site on Connect' option. You can turn it off when you're done changing: Regards,

I just installed 1.1.28 and went into Setup to change the location (I have move to a new house). The fields for latitude and longitude would let me position the cursor in them but I couldn't change

Ron, you may need a cross-over cable to use an ethernet connection directly from your PC. -Will [email protected]> wrote:

Yahoo Mail: Search, Organize, Conquer

Thank you guys, I will try the reset and battery removal and see how it goes. If nothing than off to Mr. Herman

John since you swapped motors over it’s a fault with Gemini Encoder IC DEC PLD. ?It needs to go to a repairer ( https://gemini-2.com/G1-repairers.html ) for replacement. Sorry, it’s easily

Hi John, if you've tried resetting Gemini to all defaults, taking out and leaving out and then replacing the 3v battery, the next step would be to contact one of the repairers that is closest to you: