开云体育

AFIAK, they are both manufactured by Aveox who are based in Simi Valley, California. Sent: 04 July 2024 03:43 To: [email protected] Subject: [Gemini_users_io] Gemini 1 & 2 origin Anyone in the

USA -- Brendan

Anyone in the group know where the 1s and 2s were/are manufactured?

Brendan’s design is here: </g/Gemini_users/files/Gemini%201%20Bluetooth> and you can find mine here: </g/Gemini_users/files/Gemini%20Bluetooth> Cheers David Sent:

Thanks Brendan. I'll pass that on. Would you post a link to the DIY wireless projects. Best Regards, Russ

Russ this guy sells Gemini: Gemini WIFI (

Someone on Cloudy Night has asked me about how I control my G11/G-1 wirelessly via SkySafari. I see that the SkyFi wireless hotspot module is no longer being sold. What are his options? I occasionally

I'm trying to remember what version ( https://gemini-2.com/pcb-pictures.html ) G1 is the system??? If earlier version (not last ver3) does it have dual SOT23 diode D10?? See image If so these fail

Power loss could result in some corrupted settings with G-1. While it shouldn’t cause stalls, corrupted settings have been known to result in some very strange and unexplainable behavior. You could

Sure sounds like the motors should not have a problem. The black anodized mount will heat up very quickly in direct sun! It can get really hot. Also, Losmandy black anodized aluminum is known to turn

Michael Thanhs for the ideas. ?Never in direct sunlight unless I specifically open the RORO roof during the day like I did today. ?I have 2” thick polystyrene in the roof and walls so tends to be

First thing to check is the power supply voltage. Can you put a meter on it and monitor during a slew? The motors are the only parts that run on the full voltage of the supply. If the voltage is low,

Hi folks i have not used my Gemini 1 L4 for quite a few weeks now. ?We had a power cut or two. ?One was three hours long and enough for the UPS to run out. ?That was a month ago. ?Today I went

Brendan, I respect the handson experience of seasoned users. Additionally, I would have had to craft a new socket so I wouldn't risk plugging a 12 volt GoTo into an 18 volt socket. I'd rather have a

The system runs fine on 12V DC. ?I ran my own on a computer PSU 12V out for two years. To many obsess about the need for a higher voltage! But basic forces in a motor f=“sintheta BIL” where

Hi all When I am booting up, whether cold start or warm start, ?my Gemini 1 if I don’t enter the menu quickly, within 20 seconds or so, the hand control goes blank with no script response. I can

Response to 15 volts. I recently bought an GM8 and running it off a hardy garden tractor battery. Even though everything is working well, I'm probably missing something. Would I find value by adding a

Depending upon your version type of PCB (see here ( https://gemini-2.com/pcb-pictures.html ) ).?? Below is an image of D10 on a Gemini 1 ver 2 pcb and ver 1 PCB.. Version 1 and some version 2's have

A fuse that might be at fault: https://gemini-2.com/faqG1.html#Q13 ( https://gemini-2.com/faqG1.html#Q13 )

I suspect that it is an issue of voltage. You must provide at least 15 volts. Gemini loves 15 volts :-)