开云体育

I have now been able to try a second identical hand controller and the behaviour is the same. So it doesn't look like a problem with the controller, more likely in the Gemini itself.

Hi Paul, Okay, I should have looked at the screenshot before sending! :-) The worm period is not calculated correctly when less than the total number of cells is used. -Ray Sent: Saturday, March 30,

That sounds like you just have the mount set to Guide mode. When moving at Sidereal or at guide rate, you’re not going to hear the motor. You need to get to at least centering speed or slew speed.

Hi Paul, Thanks for replying. After displaying Sidereal Mode on the controller, the screen goes blank. When you press any tracking buttons, either in RA or Dec, there is no message on the controller,

Hi Paul, The maximum possible worm cycles are calculated by taking the total number of cells(command 503) and dividing it by the multiple of spur gear ratio(command 23) times RA encoder

Hi David, do you get any messages on the controller? Stall messages, heavy lag tr messages? Do the motors work when you do a Goto or use HC buttons to slew? Did you try swapping between RA and DEC?

I have a Gemini 1 L4 controlling a G11. I have just replaced the CR2354 battery with a new one measuring at 3.3v. I cold started the system and successfully set all the parameters such as mount type,

Ray -- one problem I see is that regardless of what Gemini or the ASCOM driver are configured to for PECMax (usually 6400 steps for Gemini-1/G11), PEMPro tries to retrieve or program 2x the worm

Hi Ray, That would be my first guess is that something is being set or used as if this is a Gemini-2 L6 mount. After a quick check, I don't see anything obvious, though. Mark -- can you please share a

Hi Mark, Perhaps the error is that PEMPro is sending a command that the earlier control boxes don't understand. Please use the PEMPro Log zipper on each computer and have it zip the Debug logs for the

For the most part, most (if not all) software that works for G1 also works for G2. For me, I’ve been using N.I.N.A. for a while and can highly recommend it and others have used APT, sharpcap etc.

What do you want the new software to do? For a planetarium app I have been using Sky Safari 7 Pro connected to the Gemini 2 using a nano router for many years. It's an excellent combo. -- Chip Louie

With a Gemini 2 and full L6 firmware the ASIAIR works very well and is very reliable. GOTOs.using plate solving is brilliant and tracking while autoguiding is excellent and reliable. There is a minor

Thank you. I think I might buy one.

Thanks Paul. ?Just to let you know, yesterday I swapped out the PC for an older slower one with just pempro and Gemini latest version loaded. Got exactly the same results. ?So that is 4 converters,

Yes. ?You’ll need to do an alignment on the Gemini II, even if it’s a “fake” one. ?Works well, but occasionally I find that it doesn’t go home after an imaging session. ?It’s very

I recently purchased the upgrade from Gemini I to Gemini 2. I have watched most of the videos on the Losmandy site. I saw a couple of references to software such as Stellarium. Does anyone have any

Mark, thanks for uploading the new logs. I'll take a look over the weekend to see what I can find and let you know. Regards, -Paul

Tried correcting the time but no change - and I have now disabled Dimension 4...

Hi Paul, plenty of people use these mounts with the Air so yes, they’re compatible