开云体育

Yes most cards will work we don't have go after the fastest class card....I've seen C10 8GB is more than sufficient.? You really don't need large? capacity cards.?? Do format the card (FAT32)?

Stefan we use an 8gb card here at the shop -- Brian Brian Valente portfolio brianvalentephotography.com <http://brianvalentephotography.com>

Hi there Brendan, Thank you for the feedback. I have a feeling it could be the SD cards that are the problem. Will the kingston 32GB micro SD card work? or do they have to be the 2 GB ones? Cheers,

Hi Micheal, Yes, I will send it to you. The unit will boot up, but no rs232 communication. Paul

Dear Paul, I recently repaired a similar unit. It is unfortunately common to have a serial port chip or it's surrounding capacitors blow out. That unit had a MAX232 Maxim chip and 1uF ceramic caps. I

Thanks for the Gemini 1 advice, Micheal. Can you help me troubleshoot a Gemini 1 board? I think a power surge took out my unit. It no longer communicates with the PC. I have attached a photo of a

Paul, I follow the advice below, to avoid the persistent problem that Daylight Savings Time date can change. The G-1 cannot know of those date changes. So it is best to only enter UTC time. See below.

Hi Robert, Just tried the exact configuration you have, and still works fine. I suggest you uninstall and then re-install the driver and the ASCOM platform. Perhaps something got corrupted in the

Windows 10, Apologies, I thought that I had included this

Looks OK, Robert, but which version of Windows? 7, 8, 10, or 11?

Hi Paul, Ascom Gemini version 1.0.75.0 Thanks. Regards, Robert

Hi Robert, I tested Gemini.NET with ASCOM Platform 6.6 and everything worked. What version of the driver and what version of Windows are you running? Regards, -Paul

I downloaded the latest ASCOM platform, version 6.6.? It does not let me start the Gemini.Net driver.? I have had to downgrade to Version 6.4.? I cannot find 6.5 which I had previously. Is? anyone

Michael I have gemini motors, but they are Din-style, not RJ will that help?

Forgot the photo...here is the Gemini-1 unit for which I seek one or two matching motors and cables. Thanks again, Michael [email protected]> wrote:

Hi all, I do repairs for Gemini -1 owners. Sometimes, I get an older unit that has the rectangular motor connector (CAT-5 type cable). See photo of the front of these older units. As I have none of

nice one Ron. that makes sense too [email protected]> wrote: -- Brian Brian Valente portfolio brianvalentephotography.com <http://brianvalentephotography.com>

Thank you all for your consideration and suggestions I think I have found the answer to my reoccurring ?“communications error ! “ messages As Brian has suggested I did not reset anything and

Hi Stefan there is a MicroSD card in the HC ( https://gemini-2.com/Removing_SDCards.html ). These can come lose (with constant knocks) and sometimes needs reseating. ?It’s an easy task, shown in

I had this happen again, and I noticed that similar conditions occured. 1. The mount was ending an imaging run pointing West at Target Coord (JNow) => RA=08 11 39.216? DEC=-12 53 05.52 2. The mount