开云体育

Hi David, do you get any messages on the controller? Stall messages, heavy lag tr messages? Do the motors work when you do a Goto or use HC buttons to slew? Did you try swapping between RA and DEC?

I have a Gemini 1 L4 controlling a G11. I have just replaced the CR2354 battery with a new one measuring at 3.3v. I cold started the system and successfully set all the parameters such as mount type,

Ray -- one problem I see is that regardless of what Gemini or the ASCOM driver are configured to for PECMax (usually 6400 steps for Gemini-1/G11), PEMPro tries to retrieve or program 2x the worm

Hi Ray, That would be my first guess is that something is being set or used as if this is a Gemini-2 L6 mount. After a quick check, I don't see anything obvious, though. Mark -- can you please share a

Hi Mark, Perhaps the error is that PEMPro is sending a command that the earlier control boxes don't understand. Please use the PEMPro Log zipper on each computer and have it zip the Debug logs for the

For the most part, most (if not all) software that works for G1 also works for G2. For me, I’ve been using N.I.N.A. for a while and can highly recommend it and others have used APT, sharpcap etc.

What do you want the new software to do? For a planetarium app I have been using Sky Safari 7 Pro connected to the Gemini 2 using a nano router for many years. It's an excellent combo. -- Chip Louie

With a Gemini 2 and full L6 firmware the ASIAIR works very well and is very reliable. GOTOs.using plate solving is brilliant and tracking while autoguiding is excellent and reliable. There is a minor

Thank you. I think I might buy one.

Thanks Paul. ?Just to let you know, yesterday I swapped out the PC for an older slower one with just pempro and Gemini latest version loaded. Got exactly the same results. ?So that is 4 converters,

Yes. ?You’ll need to do an alignment on the Gemini II, even if it’s a “fake” one. ?Works well, but occasionally I find that it doesn’t go home after an imaging session. ?It’s very

I recently purchased the upgrade from Gemini I to Gemini 2. I have watched most of the videos on the Losmandy site. I saw a couple of references to software such as Stellarium. Does anyone have any

Mark, thanks for uploading the new logs. I'll take a look over the weekend to see what I can find and let you know. Regards, -Paul

Tried correcting the time but no change - and I have now disabled Dimension 4...

Hi Paul, plenty of people use these mounts with the Air so yes, they’re compatible

Oh - well spotted - I had missed that.? I run Dimension 4 to keep the PC time real just in case I do any exo planet measurements - it may have caused the issue as it impact the PC time but not the

Brendan Actually - good point.? I have tried to slow it down but connections reverts back to 9600.? I'll try that...? ?Have 3 FTDI usb to serial cables, all new'ish so thanks for the offer...

Ray Yes - tried all available ports.? Serial cable (DB9 to RS232 4p4c) is 2 foot long, untwisted pair cable but also unshielded.? The FTDI to USB are all very short too (I have 3 of them, plus now

I noticed what looks to me like an odd valued (arbitrary)TOD difference between computer and Gemini in your Ascom logs. Not sure if this would impact what you're trying to do,? but wanted to be sure

Hi gang, Is the ASI Air compatible with Gemini II please.