开云体育

Thanks, Paul Luis El vie, 23 feb 2024 a las 19:49, Paul Kanevsky (<yh@...>) escribió:

HI Luis, the model is saved automatically and will be re-used automatically until you clear it by doing a Cold Start (or a Gemini Reset).

One question, Each time that you perform a pointing model ?is it necessary to save it, and download after the new warm restart, or Gemini 1 does it automatically? Luis

Macdonjh, I have experienced the very same slewing error at times but it is intermittent. I doubt it is your alignment; I drift align every time and check with PHD2. I also can easily hold a star for

Jonathan and Paul Kanevsky, Thank you for responding.? I hate to think my polar alignment is bad.? I spent a long time over two nights doing an old school drift alignment.? It takes five minutes

Hi, With Gemini 1 you'll want to make sure that the Gemini.NET ASCOM driver is set *not* to use precision pulse-guiding option. That didn't work well in G1, but became the default, and only option in

I have found that bad polar alignment can affect orthogonality measurements as the star drifts while phd tries to measure dec movement. Also large PE can affect that as RA drifts during the

Hello Gemini I.? I realize I may also have an MI-250 problem, so I've cross-posted this. I've been working through all the growing pains of a new imager.? I think I'm close to getting useable data,

Dale, Mike is the best! I think he'll have you back up and running in a jiffy no problems. But a bit of.lick can't hurt! Cheers/Chip -- Chip Louie Chief Daydreamer Imagination Hardware Astrospheric

Many thanks to all who have responded! Things are indeed looking like we need some professional help, and Michael Herman is local-ish! Will send a final update after we're operational! Thanks! Dale

And the original battery is difficult to obtain although I did buy two via Amazon. -W.

There I go again fat finger typing. ? CR2032 is correct SMD type, not CR2302 sigh. -- Brendan

Hi Dale. the battery for that PCB is a SMD (Surface mount type) CR2032 battery and holder with side positive clip (positive is towards the top of the PCB. ?That’s if it’s defiantly that version

Which battery holder to fit depends on the board revision, as the footprint of the holders used are different. It’s possible to use a 2450 battery holder with an early PCB but it does involve

Hi all, figured I should join and post to this group rather than the Gemini-2 now: My club has recently obtained a G11 with Gemini-1 board shown here: https://gemini-2.com/pcb/GeminiPCB1A.jpg We

I will add these two settings to the notes on spreadsheet if not already there. Thank you Paul

That was exactly the problem, Paul. I had checked the "Flip using Go-To" but not the "Report pier side" box. My GM811G HD is working great again. I wasted a lot of time over one unchecked box. I'll

Thank You Paul! I sure appreciate the help. OK, found it. Will continue my Daytime flip attempts.

it’s part of the telescope settings screen, Sonny. I’ll post a screen shot when I get back to the computer. Regards, -Paul

Hi Paul, Thank You for checking in on me. OK, just going by what I saw when trying to sign on. At least I did get here, so I'm happy. I've been trying to find the screen you are showing, but no luck.