开云体育

Hi ?, I'd start by resetting Gemini completely by taking out the 3v battery for a minute or two, and then replacing it with a new, fresh one. **Interrupted** message usually indicates that Gemini

Hello guys, my Gemini System runs about 24 years without a greater problem. But now, i have a problem with this system. If i want to slew to an object, the system make a slew, goes into centering mode

Everything looks in good Nick polar scope,CKS clutch knobs and the 127 looks good yes older motors but they look in good nick -- Brendan

Thank you for the links. In Photos, I just created the folder "Tom Losmandy G11 Photos" and within this folder are the two seller provided photos. The motors appear to be old discontinued standard

Tom you’re good, Paul answered better than I could. ?He’s a wealth of knowledge. Take pics ….we can analyse them. Check axes are smooth and clutches engage but allow slip. ?Try to skim the G1

Thanks for the help. Cross posted - I was not sure if my post got through here, being a 10 minute old user. Regards Tom

Tom I think there are workarounds for the camera to get it working. Check the mount boots, you don’t get SRAM reset or off things on boot. ? The Gemini 1 keeps settings saved in SRAM that are saved

Hello, I'm looking at purchasing a G11 this weekend. The drive is about 3 hours and I have limited knowledge of this mount - it will be my first equatorial mount. From the photos sent, it is last

I just want to be clear synchronizing each target is on the Air Object screen not on the G1 hand controller.

1) Goto no RA-Dec update I think I figured something out I had this happen last week. For some reason I got to thinking about this and went back to last target. I had been synchronizing each target

Hi Trevor, thanks, that's what I wanted to find out. Initial L6 release did have some issues with Southern hemisphere that were fixed in L6.02. Since you're on L5 still, these are not relevant at this

Thanks for all that but I don't actually feel comfortable with the prospect of doing all this for an upgrade when my current system works OK - as I asked are there any special requirements with my

Hi Neil, Goto limit was indeed introduced in Gemini-1. It defines an zone (in degrees) prior to the safety limit where a Goto to a target will result in a meridian flip. Default is 2.5 degrees or 10

Hi Paul Sorry, I forgot to answer your question on the ASCOM driver in use [image: image.png] -- Thanks and Best Regards Neil

Hi Paul Safety limits in Gemini are: - West 123 East 98 [image: image.png] Is a goto limit different to a safety limit? I don't see any goto limit settings anywhere. Maybe it wasn't a thing in

Hey Neil, What version of the ASCOM driver are you using? Also, what are your Eastern safety limit and Western Goto limit settings? These all play a part in the meridian flip calculations. Regards,

Neil, Interested in this too as I just (last week) found this video. - Jerry

Hi All So I'm doing some testing with N.I.N.A and focusing (no pun intended) on the Meridian flip. I've watched the Losmandy podcast where Edward Plumer covers this topic in wonderful detail and I'm

Thanks for feedback Bill. well done, cheers -- Brendan

Yes, it turned out to be a bad cable.