开云体育

I’m experiencing a new and troubling issue with my Losmandy mount and seeking suggestions/guidance. After roughly 100 successful sessions since receiving the mount (GM811G w/level 6) in 2023 I’ve

Hi Larry, You will probably find the cables to the RA and DEC motors will not reach the controller in the lower configuration. That is why mine is on the 12" column extension. Works fine there and has

Brendan, Great information. I don't see anything of that nature visible. So, I guess it will be heading off to Losmandy next week for repairs. Just fount a problem with my 50" TV set in the spare

Yes parts are available. ?But H bridge is a little tricky to R&R. ? The repairers have all parts. But a pwr surge you can guarantee more than one IC part is damaged. ? But that’s the job of

Thak you for the information. There is not a second input attached. I have bench tested the unit without the motors, so that is out. I too suspect and IC or the H bridge. I have not checked the ICs

Neil Do you have the 2nd 12V power out connector plugged in! ? If so remove this and power on. ?It could be an accessory on this line drawing too much current. ? Yes it has 2 fuses one for each

I have discovered a problem with my G2 system today that when I power on the system the switch light comes on from a few seconds and the goes out. At that point I turn off the power switch and check

Folks, I heard from Losmandy that a batch of boards disappeared during shipment to AVEOX 4-5 years ago and was never recovered. These appear to be those boards. Boards sold on Fleabay are not 100%

Ahhh yeah I’m guilty I received it as a test FW so numbered so I knew which was which. ? But it’s the same checksum as Paul David said. ?It became FW3.0. ? So no difference and a mistake by me.

Awesome. Good to know. Thank you.

The v3.0 in the Files section here is the same as 3.1 in Brendan’s photos. That’s the high torque version.

Ok. I was seeing reference to a higher torque fw on a old thread. Is that in the “latest” v3.0? If so, it’s interesting that didn’t trigger a version change.

Here's info from Losmandy: We supply all wrenches that are needed for the mounts in the original packaging. The wrench you need is 3/16” Regards, -Paul

I was wondering the same thing, so I asked Brendan, since he appears to be the only one in possession of? FW v3.1 :) Turns out it's the same as what's in this group Files and what Losmandy ships

For clarification, there’s little difference between 3 and 3.1. Scott shipped version 3 of the servo firmware. 3.1 was a slightly later build (days) with a change to the means of communicating the

In playing with this all ive come across an interesting question. what is the latest servo fw? Ive seen screenshots of someone's HC showing Servo FW 3.10, and there appear to be several versions of

That looks correct and had to be as Losmandy uses US Standard thread here. ?If other tools were used this might gall the bolt edges. ?Assuming a G11 RA, the back Altitude Screw plate secures with

These fasteners look like the usual suspects.? The issue is most likely that your Allen wrenches are poor quality and/or out of spec.? Experience has shown me that stainless steel socket headed cap

Use E-Putty to glue the Allen Key into the rounded head.

If you have tried using a better quality Allen wrench and still not able to get the screw out it probably means the allen slot has become rounded over. You could try the following. Wrap some aluminum