开云体育

I have bought this card and programmed the ARM processor and the pics with available files. To my understandingit works, the hand controller shows the right software versions when connected.

Hi Bren, That's what I figured so I bought it.? It says it is returnable, new and guaranteed to be working.? Should get here in a couple of days, we will see... -- Chip Louie Chief Daydreamer

I would return it (I would not have bought it in the first place actually). Then, if you really want a spare, buy a genuine from Losmandy. IMHO. -- Sonny Edmonds GM811G HD

Welcome to the Human Race, David! You are not the first, probably not the last. Congratulations on your new G11! -- Sonny Edmonds GM811G HD

Yep! That was it. Thank you SO MUCH. I knew I was doing something wrong...

Is it possible that you have the RA cable going to the Dec motor and vice-versa? The cables are identical, so it’s not uncommon to mis-connect them. Worth checking. Clear skies K Walsh

Well it’s all there. ?The ARM is missing its sticker so no FW or bootloader installed. ?Cannot quite read the dspicc sticker they may need flashing as well I kinda wonder how these got on fleabay

Make a copy of your G2 mini's micro SD card and then program the bootloader that has just been released and also program the servo PIC chips.? Maybe it will work? -- Chip Louie Chief Daydreamer

Brendan, Here are pics of the PCB: Yep, I'm guessing the ARM is blank.? Anyone know how to flash it and with what? Does Losmandy flash them or buy them already flashed?

Hello all, I am really struggling with my new G11. I have it setup with a dual scope saddle so the mount's saddle is rotated 90 degrees. I have confirmed the lat/lon/time and timezone are correct. I

It looks like a proper PCB. ?Post some pics front and back we can tell. ? Sounds like ARM is either dead or blank cheers -- Brendan

I found on eBay an ad for 'AVEOX PCB 3050475-00 REV F Conrol Board ASSY' as New Open Box.? There a few listed from various sellers. It appears to be the exact PCB used in the latest Gemini 2

John Some routers you can log in to and see if the Gemini is being seen on your router (or network). ? Aka to find if the Gemini is on a different Ethernet address, for some reason. By far easiest is

Thanks Chip! I will definitely check oiut this solution.

Apparently the unit I have in a Gemini 2 "original", as Brendan said, "tall boy".? When I open GeminiTelescope (which itself is pretty old), the only option I see in Telescope set-up is ethernet,

FYI: there are user manuals for the mount ‘and’ Gemini. Losmandy has some good documentation on PhD too.

Hey guys, Thanks for the replies. I actually have read the User Guide and watched most of the videos but somehow I missed the part about the cold start in CWD position. That should solve one of my

The G11 manual is pretty good. You’ll pick up a lot a needed info is you read thru that.

Hi Bren, As you said, let's just wait for Trevor to test with the fixed HC. I have no idea how the HC can show a different PIC firmware version than what's reported to the PC. Both are serial commands

Hi Dave. ?You may be best to start at Gemini FAQs here ( https://gemini-2.com/Getting_started.html ) on setup and running. ? There are quite a few videos to watch as well. May be best to run mount