开云体育

Thank you Chip. Do you recall which setting? Art Trailattrail1@...

The HC will display a warning if the battery is running low when starting up. Yellow warning if it should be replaced soon, and red if it needs to be replaced now:

I don’t want to hijack this thread, but how do you check battery voltage directly on the hand controller, as Paul said can be done? TIA.

Paul, Today I've been investigating the Bad Checksum and Exception errors, which I posted earlier. As I got another MeLE Quieter 4C for my another Gemini-2, I setup the exactly the same configuration

You can only access it using the UI through a web browser. -- Chip Louie Chief Daydreamer Imagination Hardware Astrospheric - South Pasadena, CA Astrospheric Signature (

This is not a Gemini 2 issues so much as one of your apps is pushing setting data or pulling setting data from elsewhere in the system.? Several other N.I.N.A. users here hav

Checked the manual can't find anything re setting alarm thresholds, thanks

As Paul said. ? This is only on older ARM processors that have not been made for a long time. ?The problem is/was an internal microcode hard bug. ? ?As said fixed by mfgr, your G2 will have a

Thanks for your help, Paul. Art Trailattrail1@...

If you're having issues with automated meridian flips, then it might be worth trying. This has no effect on plate solving or pointing accuracy.

Ok. I’ll give it a shot.How about “flip on goto”? Is that a good one to have enabled? Art Trailattrail1@...

There's no way for me to tell if that's right or wrong for your setup, as it depends on the mix of software and drivers and all of their individual configurations. Since the error sounds within the

Paul, that is checked. As it used to be. I would think that it should stay that way? Or am I wrong. "Gemini Calculate Refraction" in also checked. Is that OK? Thanks, Art

Try the precession setting in Gemini.NET. You may need to change it (check or uncheck):

Hello all, I just recently upgraded to the latest Gemini.net driver, as well as turned on RA/DEC 4x Step Res. I am at L6.12 on the G2 On my very next session, I was not able to accurately plate solve.

This is the error condition described in the LPC2388 CPU documentation. The moral of the story is turn on your Gemini after replacing the battery, and set the date/time:

No damage would occur if you didn't set the date/time, but older Gemini-II units may cause the battery to get discharged very quickly. You can check the voltage of your 3v battery directly in Gemini

My Gemini2 has version 6.0 firmware. I purchased the HC and Mini controller in summer of 2024. I had set up the unit and things were operating normally. The internal battery did need to be replaced

It's worth a few weeks wait! Especially considering that we all waited for the new bootloader for many years without knowing that we need it ;)

Any modern SD card with normal speed specs would be fine. Gemini isn't doing anything nearly as intensive as storing real-time video or even large images on the SD card. A few configuration settings