开云体育

Typically, I do a warm start if and only if the mount is still at CWD when I power it up. Further, the mount "knew" where it was for the first part of the session before comms was lost. Will do, but

Hi John, Yep, that would scare the heck out of me, too. Something I've done in the past, and as recently last week (first time in a long time) is to do a "Factory Reset". *Tanya of Losmandy hosts a

Hey John, Quick question: Were you able to regain mount communication before power-cycling the mount when you found it in the inverted position? If so, where did the mount "think" it was pointed at

John, it sounds like Gemini was in a bad state if everything was initialized properly, but then it lost communications with the PC and continued to track past the safety limit. A few things to check,

Thanks Doug, to be clear the mount was NOT parked as the software/driver lost communication.

Hi folks, An updated version of Gemini firmware L6.12 is now available. This fixes the reported issue where PEC, once programmed, can't be turned off and must be cleared to disable. Update your Gemini

Concur with Dale. PEC selects and deselects normally again. Works on the desktop hand controller as well as through PEMPro. Thank you Rene and Paul!

This seems to have fixed the issue. PEC on/off is fully controllable via PEMPro now. Thanks Paul and Rene ! Dale

Viewing this, could not this come about tracking past the west horizon.? Started west of the limits tracking does not cross them.? Check that the mount ended the session Parked.? If a secondary

Thank you Paul and Rene! Will try it out this afternoon if I can

Hi Ryan, Dale, and others using PEC with L6.11, René investigated the PEC not turning off issue in L6.11, and has produced an updated firmware L6.12 to resolve this. Please test with your Gemini and

By the way, my limit config -

I woke up to my telescope as shown in this picture. Somewhere around 11PM the mount disconnected - second time this has happened recently. But what troubles me is that the mount continues to track and

I have a new G11/Gemini-2 that I bought last summer. I've set up a Home park location of due west, and park it when I'm done each evening. I've noticed that if I leave it unpowered for more than a

Thanks Paul. That makes life much simpler. Rick

Thanks Dale. Yeah I couldn’t get PEMPro to change the PEC status at all and like you said, if selected in the Hand Control it would momentarily deselect and then reselect itself. I didn’t try to

Hi Ryan, I had this exact issue last night as well. I believe the only change to my system since PEMPro last worked was the Gemini-2 firmware update done yesterday. And of course, Win 11 keeps

Thanks Paul, I feel somewhat validated, lol. I’ll probably just leave PEC on for now. I only discovered it because I was playing with PEMPro this morning but my existing PEC will still suffice for

Hi Ryan, I do see that PEC isn't turning off from the HC or virtual HC. Seems Gemini is now insisting on keeping it going -- something Rene will need to check :) A simple way to overcome this from the

Good morning, Just came across something this AM and curious if anyone else can replicate: Gemini2: 6.11 ASCOM: 7.0 When I deselect the PEC container while PEMPro is connected, it immediately