开云体育

Thanks Doug, to be clear the mount was NOT parked as the software/driver lost communication.

Hi folks, An updated version of Gemini firmware L6.12 is now available. This fixes the reported issue where PEC, once programmed, can't be turned off and must be cleared to disable. Update your Gemini

Concur with Dale. PEC selects and deselects normally again. Works on the desktop hand controller as well as through PEMPro. Thank you Rene and Paul!

This seems to have fixed the issue. PEC on/off is fully controllable via PEMPro now. Thanks Paul and Rene ! Dale

Viewing this, could not this come about tracking past the west horizon.? Started west of the limits tracking does not cross them.? Check that the mount ended the session Parked.? If a secondary

Thank you Paul and Rene! Will try it out this afternoon if I can

Hi Ryan, Dale, and others using PEC with L6.11, René investigated the PEC not turning off issue in L6.11, and has produced an updated firmware L6.12 to resolve this. Please test with your Gemini and

By the way, my limit config -

I woke up to my telescope as shown in this picture. Somewhere around 11PM the mount disconnected - second time this has happened recently. But what troubles me is that the mount continues to track and

I have a new G11/Gemini-2 that I bought last summer. I've set up a Home park location of due west, and park it when I'm done each evening. I've noticed that if I leave it unpowered for more than a

Thanks Paul. That makes life much simpler. Rick

Thanks Dale. Yeah I couldn’t get PEMPro to change the PEC status at all and like you said, if selected in the Hand Control it would momentarily deselect and then reselect itself. I didn’t try to

Hi Ryan, I had this exact issue last night as well. I believe the only change to my system since PEMPro last worked was the Gemini-2 firmware update done yesterday. And of course, Win 11 keeps

Thanks Paul, I feel somewhat validated, lol. I’ll probably just leave PEC on for now. I only discovered it because I was playing with PEMPro this morning but my existing PEC will still suffice for

Hi Ryan, I do see that PEC isn't turning off from the HC or virtual HC. Seems Gemini is now insisting on keeping it going -- something Rene will need to check :) A simple way to overcome this from the

Good morning, Just came across something this AM and curious if anyone else can replicate: Gemini2: 6.11 ASCOM: 7.0 When I deselect the PEC container while PEMPro is connected, it immediately

Ah, in that case all you need is the same Ethernet connection and PHD2 will bump the mount using pulse guiding ASCOM commands. You don’t need any additional connections.

Thanks Paul. The PHD2 documentation says that it can drive the Starlight Xpress AO and Starlight Xpress support staff says that PHD2 is their preferred software to drive it. I'm trying to figure out

Hi Rick, I think that will depend on the software you use to control the autoguider. I see that SX AO unit has an autoguider output, so I assume the native SX software can use that port to bump the

I have the original large Losmandy Gemini 2 controller and have been using the Ethernat port for pulse guiding with PHD2. I’m adding Starlight Xpress AO unit to my system and need to know which