开云体育

Yeah, it sounds like something else is going on. I've not been able to reproduce this, but others have. Something that Rene may need to look into. Regards, -Paul

The servo imposed limit is written so you should always be able to back out of the limit. // // If the position counter is outside the valid range only allow steps // that will move out of the

I was having issues with Nina slewing to the target after plate solving. Giving declination not reachable even though I was less than a half degree from the target. Tried updating drivers, ?ascom

Losmandy has replacement screens ? ? ?Also repairers cheers -- Brendan

I think your best bet is Losmandy directly or one of the repairers in these forums. If you are in the US Michael Herman is your guy, in the UK or Europe, David Partridge is your bloke, in Australia

On Sat, Mar 1, 2025 at 07:11 PM, YAMADA masami wrote: > > Hi, > > I have two Gemini-2 units.? One for my CG-11 (OPW+SLW upgraded) and G-11 > (OPW only). > For CG-11's Gemini-2, I've noticed that the

I hope this is not too dumb a suggestion so bear with me. If the mount was guiding when it hit the safety limit then the speed was likely set to guide rate. Trying to move the scope away from the

So sometimes the buttons work at the safety limit and at other times they don’t? Try to pay attention next time what might be different between these scenarios. Maybe we can find a way to reproduce

Yes strange but it only happens to me occasionally (rarely) in these situations. Next time I will get some logs and some supporting docs. Ken

Strange, as I seem to be able to use both, the tactile buttons in the back and the touch-screen buttons in the front to move out of the safety limit. Going past the safety limit works at centering

Hi Paul - thanks and my situations were just during normal imaging sessions with a target that tracked into the mount limits. The HC and virtual HC buttons didn't work similar to what I think David is

Is there a source for replacement touch screens for the G2 HC? 3 year old GM811G screen has been damaged by sun UV exposure over time, such that it is difficult to read. Thanks! Dale

paul, I don’t know about the original poster, but i can attest to my experience. Every time i hit a safety limit i am unable to move it without going cwd first. which makes setting new limits

Hi masami, glad you were able to find a work-around. I suspect some firewall setting on that particular network int

Ken, be careful when using automation software -- it's entirely possible that a command was sent to Gemini put in a park state while waiting for the meridian crossing to do a flip. Gemini has multiple

Hi David, I've not had that happen to me. Were you trying to use the touch-screen or the physical buttons? Did you try the ASCOM driver virtual HC buttons? Does it happen every time you hit a safety

I have had that (albeit rarely) and usually when it was approaching a meridian flip - odd because it handles flips 99.9% of the time. I usually tell it to park at CWD and then goto the target again -

I was resetting the worm mesh on my G11 (I'd been getting RA stalls) and during testing I hit the RA safety limit. My problem is that I couldn't use the arrow keys on the HC to move the mount after

Just a quick follow-up.? I fired up Gemini last night and the date on the HC was accurate.

Paul, I'm sure I've found the solution to solve this issue, though I don't know exactly the mechanism of the problem. My Gemini-2 for CG-11 (SLW&OPW) was directly connected to my NUC #2 without