开云体育

Did you change any of the settings? You said you have a 93° safety limit. This translates to 12 minutes of tracking past the meridian. If ASIAir stops at 1 minute before,? then a total of 13 minutes

The flip failed again this evening. However I did notice this clock countdown on the hand controller screen with the word Guide. I did not notice at what value the countdown began (probably at 60

Kurt you can identify your motors by shape see web page here ( https://gemini-2.com/Losmandy-motors.html ). But in short if the motor has no cooling fins it’s the old std motor. ?But I’m general

Our club scope is mounted on a Losmandy Titan mount. I noticed that our Dec servo motor has no identifying numbers on it, but our RA servo motor has? Losmandy SVM-HT marked on it. I know that the RA

You don't have to use flip points, these were introduced as an option with Gemini L6. If the two checkboxes are unchecked, your safety limits and the Western Goto limit will be used instead of flip

Thanks everyone for your input. However one question remains open in my mind. Should any of the two boxes on the screen of my pic (attached), showing using eastern or western flip points, be checked?

Hi Bruce, can you describe in more detail what didn't work with the three computers and w

How good is your polar alignment? If it's very approximate, you may have to keep adjusting DEC to track the sun.

Sounds like battery was low and system clock stopped. ?Other data was held in eeprom. Replace battery but probably do a factory default reset as you don’t know what else is corrupted. cheers --

Hi, group, I'm hoping this has been solved before. I was trying to track on the sun. During the process I realized that to correct for the sun's drift in time I had to use the dec button on the hand

Hi Tony, Both your Eastern and Western Safety Limits are set to 93 degrees... or 3 degrees past the meridian. The point of Meridian Flip = Western Safety Limit - Western GoTo Limit. Your Western GoTo

NOTE: By "Manual Swing" I mean running the mount with the Gemini II Hand Controller. Not physically moving the mount. -- Sonny Edmonds GM811G HD

Hi Tony, Doing a meridian flip was my Bain to getting NINA to flip. Here is a part of my journey. [email protected] | OK, so close but yet, so far. NINA and Automated Meridian Flips... still. (

With AsiAir, I'm stopping tracking at 1 minute before Meridian. I've also tried stopping tracking at 5 minutes before Meridian. As for the actual AsiAir command after Meridian, I've tried 5 minutes,

Gentlemen, I am experiencing a similar problem.? My mount computer is a rasperrypi running Stellarmate all up to date using INDI drivers.? Worked fine for two years then got flaky.? Replaced

What ASIAir settings are you using to configure meridian flip?

Is there anyone out there that can provide some insight on this setting?

Looks like something may have burned, the board looks pitted near the L6205 bridge driver.? Maybe I'm wrong and a bit of cleaning will show it is not damaged.? But that's a dual bridge power chip so

Hi David, That sure doesn't look good :( If you are willing to try, use a q-tip dipped in Isopropyl alcohol (the 99% kind) and gently try to remove the gunk and oxidation where it's visible. Follow up

I have my G11G in a backyard observatory year round. During the winter months (when below 32F anyway) I always bring the electronics inside...was afraid from the get go of that happening to me. Good