开云体育

What ASIAir settings are you using to configure meridian flip?

Is there anyone out there that can provide some insight on this setting?

Looks like something may have burned, the board looks pitted near the L6205 bridge driver.? Maybe I'm wrong and a bit of cleaning will show it is not damaged.? But that's a dual bridge power chip so

Hi David, That sure doesn't look good :( If you are willing to try, use a q-tip dipped in Isopropyl alcohol (the 99% kind) and gently try to remove the gunk and oxidation where it's visible. Follow up

I have my G11G in a backyard observatory year round. During the winter months (when below 32F anyway) I always bring the electronics inside...was afraid from the get go of that happening to me. Good

Yeah, I have an email in to Losmandy - I might make the call soon if I don't hear back in a bit. This is a pretty much a new mount (last Nov) with not that many nights of activity yet. I had peaked

Wow, what a mess. Hard to say if just moisture did that or there was some corrosion building up over time and the moisture on top of that did it in. Looks like it's time to call Losmandy and see if

Well there it is ...

Though situation. As you most likely thought, moisture may have gotten on to the circuit board.? You could try taking the front face plate off and use a hair dryer to make sure all the moisture is

Had my rig out last night and frost stuck to just about everything. I was waiting for the melt and evaporation this morning as it warmed back up before covering. My Gemini 2 is now holding a constant

Darryl, I finally had a clear night to experiment more with the G11G L6 and PHD2. This is again the C11 kit which runs with 43# of counterweights and no PEC training. I've not spent much time delving

On Wed, Jan 22, 2025 at 11:11 AM, Ryan wrote: > > This may need to be a different thread, but something else that has been > happening at L5 and L6 even with updating the firmware. > > When i click

I can do multi directional slewing with the manual buttons, but the touch screen works best for me with a screen stylist pen thing. (Touch screens don't like my finners.) But when slewing, my Gemini2

It's more complicated than does it work when very cold or hot.? While an antiseize paste like MP-50 can reduce the chances of metal parts seizing under pressure better than a general purpose

FWIW, MI-250 mounts (I have one) use the MP-50 lubricant.? Works great in all temps. ?Doesn't separate, harden or anything like that. In the almost 20 years I have had this mount, I regreased it

Hi Bob, I used to be a Doc Clay advocate many moons ago when I bought my first LX200 back in early 1992.? But he changed.? After buying a scope a few years ago that Dr. Clay advertised that he

Chip: Thank you, for the feedback. I appreciate your thoughts and agree about the lubricants. Losmandy does not advertise the Lubricant Kit so I emailed Tanya - hopefully they still carry it. My

Only the very cheap, poor excuse for grease known as white lithium grease is really susceptible to breaking down and drying out and turning into the nasty hard powder that gums up precision machinery.

G11T w/Gemini 2, new since last May, permanenty mounted on pier. I wanted to check PA last night in NINA. It moved to the first position then almost froze, I think went to tracking speed. When I

Bob, if you are going to re-grease the mount, I suggest you use the Losmandy's recommended low-temperature grease: /g/Losmandy_users/message/81238 You can also get the full kit for