开云体育

I recently had my Gemini 2 upgraded to L6 by Losmandy. Set it up yesterday. Had the scope parked but on for an hour or two. Walked away from it. When I came back, the hand controller was in a boot

I've decided for the HC reboot mechanism intentionally, it is the best method to reset all these internals of the ARM processor to a well defined state, of course after trying every other possible

Will there be an updated GFU? ----------------------- Jim W Phoenix, AZ USA

What's the firmware version of your G2? Can you upload more of the log file?

There’s a pattern in the behaviour, just before the timeout in each case we see the identical message sequence: 16:59:28.119 Serial Transmit TID:15 [0]: :GR#:GD#:GA#:GZ#:Gv# 16:59:28.121 Serial wait

I see a HC startup failure at times in the field with no LAN.? The starting sequence displays on the HC starts, waits, switches to connecting to Gemini pauses and then fails to connect.? The screen

That would be a question for Rene :) Not sure why it's not working as in G1.

That’s what I am complaining about – on the G1 you could accelerate from G to C to S David Sent: 25 October 2024 18:04 To: [email protected] Subject: Re: [Gemini-II_io] Allow speeding up

I tried with the other G2 – that was the last log of the set you received in the zip file The BT serial adapter works perfectly with my G1, and the cable tests clean for continuity ? D. Sent: 25

The tactile buttons always work for me (you must be on the screen with diamond buttons on the touch screen). They also allow acceleration to the next higher speed, but not beyond. I can't accelerate

Hmm. I didn't have that issue after the restart. I'll try a few more times to see if there's some sequence that leads to this state. Anything in particular that you do before you try to use the

Looks like it's working... but not every time. Something's wrong with the connection, serial converter, or the serial port.

Here’s the Diagnostics which seem (to me) to suggest the coms is sort of working but (for example): 16:57:14.953 Serial wait for response TID:11 [0]: :GA 16:57:14.964 Serial received: TID:11 [0]:

I haven't tried to use the serial port on the G2 I have so it's possible that it's broken as the G2 wasn't new when Tanya sent it to me for developing the Servo firmware. Here's what I had with my G1

Yes, I did restart – several times in fact as I’m trying to get serial coms working (but that’s for another thread). Sent: 25 October 2024 15:28 To: [email protected] Subject: Re:

The 6.05 and 1.63c betas seem to work fine using normal hand control operations for visual and with ASIAIR Plus v3. -- Chip Louie Chief Daydreamer Imagination Hardware Astrospheric - South Pasadena,

I just heard back from GL.iNet tech support and the Slate-AX is not 12v tolerant.? So as expected you need to use a 5v power source. -- Chip Louie Chief Daydreamer Imagination Hardware Astrospheric -

Hi David, Did you restart Gemini after the new HC firmware was uploaded to the HC? I had a similar experience, and it all cleared up after restarting Gemini. Regards, -Paul

I've just applied 6.05 plus 1.63 to my G2 and HC. I have "allow speeding up" set, so I expected the HC buttons to work like the G1, going from Guide speed to Centre speed to Slew Speed if I hold

I have L5 hardware and was wondering for southern Hemisphere are there any special requirements in the set up of the mount or while using NINA for it to perform a meridian flip, thanks