开云体育

Is there any need to keep it for the future?

Yes, I was near the limits, but the spring was too tight, and has been for a while because I have seen the "RA Stall!" before I upgraded to L6. No light or heat. Apparently when there is an "RA

Well, this is all very helpful - and clarifying. The interplay btw software, mounts, OTAs and photography equipment is complex, especially for those of us who are relatively new to this hobby - and

My PICKIT turns out to be a 2, not a 3.?? I have no trouble using it with MPLAB X to program PICs.? Is it going to be sufficient for the upgrade?

Apparently, the Spring was too tight. I had seen that "RA Stall!" before with Level 5 but the mount would still function. Is there something in Level 6 that acts as a safeguard when the spring is too

The spring loaded worm must be too tight. I am going to adjust it.

I"m getting a little confused here Peter. Are you anywhere near the limits? This just sounds like an RA stall. on the screen in the picture I posted. Are you exposing it to light/heat for extended

I am now trying to get it to CWD but the HC is unresponsive, it is stuck on the screen in the picture I posted.

Is the beep supposed to be erratic? Also, it is now tracking the sun and it says RA Stall! at the top of the display. I think I have seen this is level 5.

Hi Varun as greg mentioned, you can send it back for a refund, but if you no longer require it, but you can certainly keep it as well Brian -- Brian

Hi Bernd if you reset to HGM Defaults after the upgrade (described in the readme file), 4x should be set as the default You can confirm this by going under the HC gearing tab. If it's activated that's

may have been wrapped up a bit also. no, a stall is different from hitting the limits. If you are tracking towards your limits, it will beep to warn you and then stop tracking when it hits the limit

Geoff In addition to Paul's comments, if you are using an oag you would also need to change your settings in PHD2. I want to amend my earlier comment that PHD may report incorrect settings if you are

It would not affect *actual* guiding performance, but if your values are incorrect it might affect what it presents to you. PHD2 shows values in both pix and arcsec, so the arcsec values would be off

I doubt the guiding performance would be affected if you have an incorrect focal length or ratio specified -- most autoguider software deal with pixels, internally. Conversion to arcseconds does

Thanks for these, Paul. If NINA does indeed 'override ASCOM' - let's say I changed equipment, adding the reducer after boot up and reset my NINA focal length and focal ratio settings to match the

Okay... I'll check again but this is the second set of SD cards that it has shown the problem. I reprogrammed a new set in hopes it would make a difference. Seems like if the SD card was a problem, I

Hi Geoff, Correct. ASCOM interface does not provide for NINA or any other application to change telescope properties, such as focal length or aperture. These must be set through the ASCOM driver if

Hi Bernd, Seems like this is one of those bugs that can manifest itself differently on different machines and setups. Could be that the HC connection always works fine for most users and only a few of

Check and make sure the sd card is secure. Daniel