开云体育

Hi Brendan, Thanks for the suggestions. I have examined the both the plugs on the cables and the jacks on the HC and G2 and everything looks clean and good. No dirt, fluff, bent or crossed pins. I did

Hi Brian, Yes, this is the behavior I see. At first the HC comes up at the lower brightness from startup through cold start. It gets to the home screen and briefly shows the lower brightness but then

Hi Brian, I did try disabling DHCP and setting the DHCP timeout value to 0 but no change. Just to be clear, I don’t see the HC flashing the “Connecting to Gemini…” message. It just comes on

I don't understand this exactly. Even though the box is checked for Adaptive, I can still change from Dawn Day and Night.

... Gemini always uses UTC internally. Am 09.07.23 um 12:39 schrieb peter@...:

Hi Peter, You're the boss. Of course yo can override it anytime. If you have stored it in the eeprom for permanent use by pushingStore Settings the HC will use this setting during the next startup.

Hi Rene, I just played with it, even though the box is checked, I can still change it by pressing the day, dawn and night settings. Also, I have UT set and Offset to zero even though I am at Eastern

Ah, I forgot to mention... To make the Display settings permanent you have to go back to the HC: Parameter Setup screen and push "Store Settings" to store it into the HC eeprom to be used at startup.

Peter, The HC has an "Adaptive Color" option that you find under MENU->HC->Display. If this is checked it overrides the color settings for Daytime/Dawn/Nighttime Mode by selecting the mode that is

After the update my screen was green. This morning on power up it is now blue. Why is this?

Hi Brian, hi Bill After Level6 Upgrade the HC fails any first connect! The second try results in a connect. I'm using ethernet connecton with my PC but the behaviour is the same if no PC is connected.

Hi After finishing a smooth and issue free DIY Level 6 Upgrade I tried my G11 under the sky and everything (except the HC that needs a second try to connect each time after powerup of the gemini) runs

Thanks again for posting this here BIll I have been testing this for a while on my hc here (1.57) and I am not able to duplicate the issue. There definitely has been work in this area to address prior

Hi Bill - thanks for posting this. Some of this behavior may relate to the new underlying DHCP features and underlying code we are now using. In the new hand controller firmware, the flashing and

Yes issue on PicKit 2 been discussed before. /g/Gemini-II/message/24217 sorry gents I had my browser set to latest msg first so didn’t see other replies …so I’m late to the

Similar issue reported here /g/Gemini-II/topic/99792957# ( /g/Gemini-II/topic/99792957 ) I think Paul has a “bug” link page but cannot find it. ?Must be on front

Ahhh PicKit 2! ? ?It’s of an earlier era so might have issues with newer net framework. ?But that’s strange as usually they are backwards compatible. I suggest click on “yes “ to download

Hi Bill Inspect the HC sockets (both ends) for foreign matter and bad pins. ?Use a torch and magnifier for a close inspection. ?funny thing I was working on HC recently and noticed that one of the

I set Offset to 0 and then set UT. I hope this works. Are the beeps for servos disconnected now gone? My unit was beeping before the upgrade, noy it is not and Tracking is set to Sidereal.

I just can't figure out what to do to set the time once and for all. Why is it so hard to find this information? I had found some kind of online manual a while ago. but don't know where.