开云体育

Your experience, if it's to be believed, is contrary to mine and countless others I've spoken to and read in various forums.

Greetings, folks! After what felt like an eternity of clouded skies, we finally had a night of clear skies here in germany. I was pumped to finally test the new firmware. So, with full enthusiasm, a

I assume this was resolved many years ago. Are you still having problems with your HC?

Baffled? Trying getting repairs under warranty.

Well it turns out it's a bad SD card that got sent out with the units by mistake.? Tanya at Losmandy responded with that news immediately and is sending me a new one today. My interactions with

When I bought my G11 I specially bought it from California cuz they have a 30 day return law. I immediately had problems w my Gemini. Losmandy was not much help at all. I call the reseller telling

When I had a loose cable connection at the HC or Gemini unit mine used to reboot a lot so maybe spray some DeoxIT or other on the cable pins and reseat them a couple of times. My test for cable

I have a brand new G-11 with the Gemini-II received a couple of weeks ago.?? Due to weather i've only been out three times.? I noticed my first night the HC reluctant to accept my pressing of

Rene, I would be interested in Beta Testing with you on this project. It sounds like fun. I even already have a smaller solar panel 7 watt I could utilize for results. And a lot of electrical

Hi Russ, Paul is right. I have a prototype of an AZ8 with servo motors I used to developing a Solar Tracker. This can track the sun all day with a telescope or with solar panels. Keeping the panels

I've been having this issue since I bought my G11T new last November. Tried just about everything and kept having the same issue. Went back to 6.02 a month ago and it's been working perfectly since.

Hi Russ, Scott Losmandy will likely give you a better answer. I don't own an AZ8,? but just looking at specs, AZ8 implements a variable slip clutch on both axis, just like all other Losmandy mounts.

Why not just call Losmandy, the best time to speak to them is in the afternoon. Their mornings are pretty busy which is why I’d suggest an afternoon call. Generally they can answer pretty quickly.

I'm considering purchasing the apparently fairly new AZ8 with Gemini 2 and go-to with servo motors. https://store-losmandy-com.3dcartstores.com/AZ8-Config_p_255.html But I have some questions that

Hi Andrew, the "unreachable" message indicates that your safety limits are not allowing the mount to reach that object. The usual suggestions (test all of these after you connect your PC to the

Some ideas - make sure your geo location is correct, double check your time zone is correct, check your horizon limits in your imaging app are not set too high, recheck your mount safety limits

Dear fountain of knowledge, I have been having the following issue the g11 will not goto anything on the southern part of the sky, "says unreachable" the following has been done gps Polar align plate

Oh, got it.? Do you add a network device in Windows so you can see what is being copied to the Gemini 2 using Windows explorer?? This can make life easier in this situation. -- Chip Louie Chief

Your Gemini 2 will only change IP addresses if you allow it to use DHCP.? By assigning a static IP address and unchecking the DHCP box in the Gemini 2 or HC the Gemini 2 will always be found at the

hi, I think you need to install a network analyzer on your PC, and check to see if you see the Gemini on the list. Take the IP address of the Gemini, and insert it into the INDI driver control panel