开云体育

Here's some of the latest updates I've made to the indi driver. I'd say that the highlight is the addition of safety limits and flip point's. I've also updated the ekos/kstars indi control panel so

A friend with a "new to him" G8 with the same gemini unit and software helped with testing various limit settings and was able to generate a flip with his unit with? E & W limits at 92 and WGT at

Thanks Jonathan - great idea. Just tried it. Results the same, no flip - even after a 5 min. retry. Attached is the ascom log should it prove useful.

Could you try changing the settings in CCDciel? Use “can track past meridian” for 12 minutes and “no flip until past meridian” at 0. This should be comfortably within the gemini limits. I

Thanks for the tips. The key factors are in the screen shot attached. The way is interpret this is as follows: 1. the gemini limits permit meridian flip between 8 mins. before the meridian to 16 mins.

Hi Frank, the math is correct. As it stands your window of opportunity for a flip runs from 1 degree past meridian all the way to your safety limit of 4 degrees past meridian. That is 4 minutes to 16

Frank, I don't work for Losmandy, so you're better off contacting their support directly about any repair/replacement. Your? safety limits are very conservative, so there will be a very limited area

correction between 91 and 94 degrees

Thanks. WSL=94,?? ESL= 94,?? WSL=3? these are my settings.? Assuming use of only the HC and a planetarium connected to gemini, I interpret this as permitting a meridian flip between 91 and 93

Thanks Brian for this information. Cordially envoyé : 17 février 2023 à 17:41 de : Brian Valente <bvalente@...> à : [email protected] objet : Re: [Gemini-II_io] problem with my Gemini Hi

That would mean the USB connection is poor. Maybe it's on the Gemini side, if you had tried multiple USB cords and different laptops. Probably easiest and best solution is to use Ethernet, as that's a

Frank, If you can’t generate a meridian flip from the hand controller then you probably have the limits set incorrectly. Paul

I have always used the usb method. I set up the ethernet option to troubleshoot the problem.? The communication errors only seem to occur with usb.? The failure to meridian flip happens with either

Frank, you reported two different problems, each likely unrelated. Communications error and mount failing to flip are two different things and are better diagnosed separately. Do you get the the

Things have deteriorated. Getting these errors now as shown in attached. From different laptops and trying a variety of usb cables.? The image that is hard to read is regarding an ASCOM/Gemini time

Thanks After trying various cables and laptop usb ports, the meridian flip issues remains.? The settings I used for limits and criteria in the capture software are identical to those used

Thanks!

Yes that is backlash Your guiding should work normally. The calibration only uses the north direction. You should bump the mount north prior to calibrating to take up any backlash [email protected]>

I have some curious behavior in calibrating guiding with a GM811G/Gemini II (L5.21, HC V1.41) using ASIAir Pro (V2.0/10.46), 60mm f/4 guide scope, ZWO ASI290MM Mini camera. All seems to work well

meridian flip. I will try a different usb cable and report back. I think you need to separate out the comm error issue from the meridian flip. A comm error would cause all sorts of issues which may or