开云体育

I realize that, Rainer, but even without a Gemini, it's still nice to see you! :) Regards, -Paul

Thanks Paul but I do not own any Losmandy with Gemini anymore regards Rainer

Big thanks to René, Paul, David and all the Gemini team for providing such support to the system. I have not encountered the M: file issue, and do not know what this issue is, may be because my

I understand and have experienced the clicks when the motors are not connected. This is normal behavior. Dave

Thank you Paul and René!

I am away on work in Carlsbad NM and intend to bring back my setup next time I go home. I also bought a stellarmate pro controller. I actually like the interface/app. So what I have done was brought

Hi Folks, René, as usual, has been busy with Gemini improvements. The new Bootloader is an update to the original one that was created when 2GB SD cards were all that was available :) The new

With my G11, for medium size stuff I use a 60mm Orion guidescope (love it) with a Zwo 120mm (full body not mini) for my 2000mm 10” RC I use my William Optics G71 as a guide scope w/ a full body Zwo

It is highly dependant on what your imaging system looks like.? You want the guide scope and camera combination ideally to have a 1:3? or worst case 1:5 ratio relative to your main imaging scope and

Hi Jeremy, I’m not sure exactly what you are looking for but, a simple guidescope and guide camera would be a start. I am currently using a cheap 50mm guidescope from astromania with an ASI178MM

Greetings everyone! Apologies if this has been discussed already (I did a quick but not exhaustive search through past posts), but I am looking for suggestions for a good entry level autoguiding

After a computer reset, regaining everything is a PITA. So, one of the last things has been getting my GM811G to slew to park at the end of a NINA session. I know Paul has helped me with this before.

I use the G8 Gemini II with the Nexus DSC controller and the Losmandy encoders with 311,000 tics. The mount is permanently installed. It works well. My original intention was to work with the Gemini

Hi Rainer, it's good to see you! Regards, -Paul

Hi Brendan, No it is not me, it is another Rainer, as I am still alive and live in Mexico and thanks for that about being a Legend?? :-0 Since April 2018 I have no Losmandy G11 and so also no Gemini

I suspect it is at the upper limit for my trusty old but fully updated G11G2.? In this configuration it really needs 4 x 21 + 1 x 7 to make it easier to fine tune the balance.? But I was already

That's an impressive setup, Chip! There's not much space left on the counterweight bar! ;) René Am 06.04.25 um 20:17 schrieb Chip Louie via groups.io:

On Sun, Apr 6, 2025 at 08:21 AM, Rene Goerlich wrote: > > Chip is right, and in L6 the motor encoder positions are monitored in the > servo firmware and in the ARM firmware. Pushing the RA axis may

Yes I meant using the hand controller.?? Thanks for the info.

Chip is right, and in L6 the motor encoder positions are monitored in the servo firmware and in the ARM firmware. Pushing the RA axis may result in Safety Limit violations. A Sync does not help here,