Ops I ment to say you would need a 44 tooth not a 40 to have a
complete set. Also these gears fit a Lot 2 3 4 and 5 lathe
--- In daltonlathes@..., "Dennis Turk"
<dennis.turk2@...> wrote:
Hi All
Just a note to let you all know that I have some Boston change
gears
that are correct for a Dalton lathe. I would like to sell the set
first but if no takers I will brake them up and sell individuals.
The set consist of the following gears.
1 each 32 - 36 - 40 - 48 - 52 - 56 - 60 - 64 - 72 plus a 20 tooth
for use as a slower feed gear. The gears are mostly Boston but I
think there is one or two Browning gears in the lot. There are
some
new ones and the rest are used but all aver very serviceable gears.
You would need two each 25 tooth one 40 and a 96 tooth to have a
complete set. The second 25 tooth gears is only used on a 12
pitch
thread and that is about the limit of what you can cut on a Dalton.
If you have a 25 and a 96 with this set you can cut every thread
from 10 to 72 plus a few odd ones but missing the 12.
I would like $75 for the lot and I will cover postage.
Dennis Turk
