开云体育

This is most interesting. What I find so interesting is the thread dial looks very close to the Dalton one in design. Meany thread dials use a straight cut gear and angle the body or the vertical

I don't? know if this info is useful, but I'll put it out there. The Grizzly 602 lathe has a 12tpi lead screw if my research is accurate.? They also offer a thread dial.? To be clear, this is not

Problem is there was no Daltons built with that size lead screw. Sent: Monday, December 27, 2021 6:39 PM To: [email protected] Subject: [DaltonLathes] Dalton 6" Type B-6 Metal Lathe Thread

Hi Joe I shipped the guy the worm gear with clutch shaft and knob I may still have the worm and its mounting casting. Will have to take a look tomorrow. I also sold this guy the cone pulley with the

DanLins <linscheid.dan@...> added folder */Threading Dial dwgs - Dennis Turk*

https://farmboysales.com/products/dalton-6-type-b-6-metal-lathe-thread-threading-dial

Dennis: I may be the fellow you sent the clutch to. From what you said I thought that you may have had a complete apron besides what you sent me. I am just missing the worm gear that mounts on the

Glen, Re threading dual: if you make some, I’ll take one for sure. Glenn Brooks

Yes Dan Sent: Monday, December 27, 2021 4:23 PM To: [email protected] Subject: Re: [DaltonLathes] Getting back to my Dalton Dennis, is it OK if I put these drawings in our files

I suspect they may have been intentionally removed. Perhaps the machine was "surplus " at the shop where the previous owner worked. By the way. I made a first cut a few minutes ago. Nice and quiet.

That would be perfect. John Molburg wrote:

No numbers on the very end of the bed?

Dennis, is it OK if I put these drawings in our files section? Dan

This is a picture of the nose protector on a lathe but before I had them black oxide coated. John also note the oil cup for the spindle bearing. This is what yours would lave originally looked like.

I also have a box full of spindle nose thread protectors if anyone wants on. Usually ask $25 and shipping but if anyone wants on you can have one for $20. Should ship in a small flat rate box

I see I can open them and I can enlarge them so you guys should be able to also. Not sure you will be able to print the files or not. Dennis Sent: Monday, December 27, 2021 4:02 PM To:

Glen see if you can open these files. Dennis Sent: Monday, December 27, 2021 3:29 PM To: [email protected] Subject: Re: [DaltonLathes] Getting back to my Dalton I spoke with Dennis today

Hi Glen. I tried printing them out but somehow my printer does not like the file or I need a fresh black cartridge. I think I have a full C size set of drawings down at Florence will check the next

John as your lathe has a 12 pitch threading lead screw it requires a 48 tooth gear to work correctly. It will work with other tooth numbers but only at one position on the rotation of the dial face

I spoke with Dennis today about getting his drawings for the thread dials, if I make them I'll probably make 30. I'm thinking of having them powder coated black.