开云体育

Hello all, I've done a quick search of this group's database and have found pictures of a few stands capable of stacking two DQ-10's.? ?Does anyone have more information on potential builds?? As

Playing ?pink noise though the system is a MUCH MORE SENSITIVE TEST than any music. It is particularly well suited for phase and frequency response uniformity issues. This is because the ear is a

It could affect the xmax of the driver due to the change of position of the coil windings relative to the pole piece.

I don’t believe this is normal. ?I have a second pair of DQ-10s that I stack with this pair and I replaced the woofer surrounds which were installed in the normal concave away for the listener

I didn't see a response to your mention that the surrounds were put in with the concave side out facing the listener. This is correct for these woofers.

Sounds good to me. Charlie Conger 713 472 9140

"Who's on first" you might not remember that skit...anywhoo, I tried both ways and settled on the faded red dot on old speaker as positive. Sounds better than the other way round. I'll ask Josh at

I was confused. A couple of ideas: 1. Inspecting the fuse should confirm the connection. 2. The old tweeter likely has the same connection polarity. 3. If you have an ohmmeter or continuity tester

I wasn't sure if I was clear. The new Scanspeak tweeters have the polarity clearly stamped..it's the old ones that the plus and minus are in question. So George if I pull the binding plate in back and

referring to this schematic found in the files area the tweeter - connects to the fuse holder. /g/DahlquistSpeakers/filessearch?p=name%2C%2C%2C20%2C1%2C0%2C0&q=Dq20e (

So...black/green wire. [email protected]> wrote:

Our messages crossed. The RED dot is the positive terminal.

No battery test. Besides my eyesight is horrible. I guess I'll keep investigating. If I could figure out schematic...I'm sure my answer is pretty simple..just not to me. I was hoping other DQ20 owners

What is the model number on the tweeter? Is it a new one? If you are talking about the wires coming from the crossover those have meaning but those have to matched to correct terminals on the

There's a faint red dot...looking at images for 20's...the red dot is next to green/black wire. Internet says...red dot on speaker usually sign for positive. ??♂? sounds

Nope. Looks like the paper or cardboard is peeled off. I'm assuming that those once held the polarity direction. Wire color doesn't qualify? Green/black white/black. [email protected]> wrote:

You should see a +/- ?or some other markings somewhere on the back of the tweeter, perhaps the back of the case. Lacking that, you can test the tweeter with a battery but it is tricky.

Fellas. Can you tell me the polarity of the Scanspeak tweeter. Black/white, green/black. Which is which? The back label is gone where I assumed the +/- was located. Got my new ones today and didn't

My initial reaction is that a misalignment of the woofer would be less critical than a misalignment of one of the other drivers because the wavelengths of the acoustic waves that the woofer radiates

As I wrote in my message #6532 that I sent on 01/15/2024 and as you can see in the photos I attached to my message #6534 (sent the same day) a non-negligible difference between the original woofers of