开云体育

The tweeter is now working but the super is still down. My next step is to pull and test the L5 Inductor and the 8.5 cap unless you have a better suggestion. Funning thing is the non-mirrored right

Looking good. How'd the test go?

I finished the repairs on the tweeter and super tweeter circuit. I'll install it tomorrow and give it a test. Thank y'all for all the help. Fingers crossed.

Good spotting that resistor. That's a very unusual one to go bad in these and not one I'd ever suspect. When the resistors do cook, it's those over on the bass leg in my experience. (Had a set where

Have u considered just replacing xo boards

Update. Removed each part in the tweeter and super tweeter section of the board. Tested each component and found the 6uf and the 5ohm to be bad. I ordered the new parts and plan on replacing

No problem using higher voltage capacitors just so long as they're non-polarized (bipolar) for the audio purpose here. Aircore inductors such as used in the DQ-10 are literally just a spool of wire.

Thank you for the incite. I have a question dealing with voltage on the capacitors. I was going to purchase?Jantzen Audio 0.10uF & 0.15uF?1200V caps. We will these work as replacements or is the

It's most likely the caps that are bad. Old electrolytic capacitors don't hold up over time especially after 47 years. The resistors should be fine as they tend to hold up well and when they go bad,

They were abused and stored in a car trailer in South Texas heat where the wax on the boards melted and collected dirt. I am restoring them as a project of love. They were going to be thrown away and

I have to say...I've seen a lot of early and abused 10's in past out here, but these are the nastiest, most beat up covers I've ever seen. Like an electronic horror show. Were these subjected to a

I have 2 set and never hear from piezo tweeters at all. I know the work as I wired jumper directly from amp. I used clarity caps and mills resistors and sent the part list to you. By all means do

Checking back in. I have installed the original tweeters and the replacement advent woofers from Simply Speakers and now I know what I’m dealing with. On the right speaker the super tweeter is not

Perfect! Thank you so much. Cheers. Matt wrote:

Follow Picts! They are correct <richardadelberg@...> wrote:

wrote:

For piezo brown is bottom purple top Tweeter black top of fuse to top term Purple or blue to bottom

On Thu, Dec 10, 2020 at 2:04 PM MattB <mab.switawi@...> wrote: > Ok. I have a set of DQ-10 tweeters supplied by Sheldon (thank you again). > I am trying to figure out which side is positive and

Ok. I have a set of DQ-10 tweeters supplied by Sheldon (thank you again). I am trying to figure out which side is positive and if the fuse is hooked to the positive or the negative side. Also on the

I've seen another pair in the sn 15xxx range with those polyester film caps. There was at least one dealer I know of (can't recall the name at the moment) that only sold their DQ-10s after changing