开云体育

I guess I was thinking of case hardened which would be much likely to break if bent. Thanks, Barry - N4BUQ

I have two good 2B's and a parts unit. Only the parts unit is bent but that was the result of being dropped hard (which is why it's for parts). If the shaft was hardened it would probably shatter or

Seems like a part that might be made on a small engine lathe. Not sure if that shaft is hardened and/or ground but maybe not. Thanks, Barry - N4BUQ

I’ve seen a bent shaft in my travels. The three sets I’m working on now are all straight. Steve Wedge, W1ES/4 Time flies like an arrow. Fruit flies like a banana. Sent from Proton Mail for iOS

Ken, Try sliding a small "refrigerator" magnet around on the case of the meter. If you can find a spot where it zeros the meter, glue or tape it on there. If it works, it's an easy, no risk fix. Jim,

Caps can drift. Let us know how you fare. Steve Wedge, W1ES/4 Time flies like an arrow. Fruit flies like a banana. Sent from Proton Mail for iOS

When your ONE job is to deliver a 4" long 1/4" steel shaft without bending it..... :-) I agree, tt's hard to picture it being bent after being installed. John

Steve, I'll have to check those. Thanks, Barry - N4BUQ

Check the values of C50 through C52. It wouldn't be a bad idea to check the resistors around the tuned circuit, as well. Steve Wedge, W1ES/4 Time flies like an arrow. Fruit flies like a banana. Sent

All is well. Carol saw my post here and we got everything sorted out. I downloaded my ‘cd’s’ yesterday. I am going to print them out today and bind them tomorrow. Joe – W7RKN From:

Cranking up the output of the generator helped and I can hear it better on any/all band settings (was only hearing it well on one of the AUX positions but can hear it now regardless of the bandswitch

Yes, me too. 73 QRO Gilles F1BFU since 1969 GQRPClub 15889 QRP ARCI 16979 ? Le vieux monde se meurt, le nouveau monde tarde à appara?tre et dans ce clair-obscur surgissent les monstres… ?

Yes, the SK is correct, but the sale and mailing of his CD's has been handled by a family member since then, up until now, apparently. I ordered and received some since he became SK. Tom K0SN

QRZ lists K4OAH as a SK from Feb 2018.

?I, too, suspect a slightly bent 2-B tuning shaft may be a factory installation of a defective part, occurring at some tiny percentage of production output. I cannot imagine any kind of damage or

Oh that’s ok, my TW-1 will let me hear the dips, I’ve just been tuning it backward.

Make sure that you have it on the right pin. I used about a 1V signal and had no trouble. 73, Steve Wedge, W1ES/4 Time flies like an arrow. Fruit flies like a banana. Sent from Proton Mail for iOS

The S meter in the 2-B is identical to all of the S meters used in the R-4 series, and they’re mechanically and electrically identical to the plate meter. Normally, these meters rest at S-1 or 0 mA

You have learned well, padawan! :D 73 -Jim NU0C "Paul Ellis via groups.io" <paulz67@...> wrote:

Funny thing, my 1st 2B had the same problem! I pretty much did the same. Remove the shaft, tap is straight, reinstall and restring.? I wonder if it was a bad run? Pete W1UO