Re: R7 parent board pin out
Yes, there were two versions of the Power Supply board. The early version uses a pair of bipolar transistors as a power oscillator driving a small transformer to generate the voltage for the +24 and
By
Jim Shorney
·
#84576
·
|
Re: R7 parent board pin out
OK... I have done some searching and found the TR7 files. Does anyone on
here know if there were different versions of the R7 power supply board,
not the 13.8v board, but the power supply board. I
By
Daniel W3DF
·
#84575
·
|
Re: R7 parent board pin out
AFAIK there is no such document for the R7. There are for the TR7, in both photo and table form, in the Files section of this group. There will be a fair amount of similarity to the TR7 and they will
By
Jim Shorney
·
#84574
·
|
R7 parent board pin out
Hello... I am new here. I have been looking for a document showing where
the pin numbers referenced in the R7 service manual are located on the
parent board. I understand such a document exists but
By
Daniel W3DF
·
#84573
·
|
Wanted: SPR-4 preselector knob
Looking for the SPR-4 preselector knob. Can anyone help?
Peter OZ8CTH
By
Peter Ravn
·
#84572
·
|
Re: TR7A Meter spikes
I also looked at the output with a scope and there was nothing after key-up.
Steve Wedge, W1ES
Time flies like an arrow.? Fruit flies like a banana.
Sent with Proton Mail secure email.
By
Steve Wedge, W1ES/4
·
#84571
·
|
Re: Drake R4A and T4XB For Sale
They look very reasonably priced!
73,
Gary
WB6OGD
[email protected]> wrote:
By
Gary WB6OGD
·
#84570
·
|
Re: Drake R4A and T4XB For Sale
If interested in purchasing any items listed on my for sale page,
please contact me off group through my email address.
mikew5rkl at gmail dot com
73
Mike W5RKL
https://www.w5rkl.com
By
Mike W5RKL <mikew5rkl@...>
·
#84569
·
|
Re: Drake R4A and T4XB For Sale
The same pictures are listed on my for sale webpage.
73
Mike W5RKL
https://www.w5rkl.com
By
Mike W5RKL <mikew5rkl@...>
·
#84568
·
|
Re: Drake R4A and T4XB For Sale
Additional Drake T4XB pictures;
Front ( https://w5rkl.com/wp-content/uploads/2025/04/Front-768x576.jpg )
Rear ( https://w5rkl.com/wp-content/uploads/2025/04/T4XB-Rear-View.jpg )
Inside Top View (
By
Mike W5RKL <mikew5rkl@...>
·
#84567
·
|
Re: TR7A Meter spikes
That's an interesting case. You should be aware that an oscillation will most likely be anywhere else but where you are listening. The 40 Meter instability that surfaces in some rigs actually occurs
By
Jim Shorney
·
#84566
·
|
Re: Noisy Lower Bands
I noticed it around 9 pm, CST on virtually all of 80M, 40M. I think it was present on 20M as well.
Barry - N4BUQ
By
n4buq
·
#84565
·
|
Re: Noisy Lower Bands
What time and what frequencies?
73
Stan
KM4HQE
By
Stan Gammons
·
#84564
·
|
Re: Noisy Lower Bands
That's exactly what I thought it sounded like!
Barry - N4BUQ
By
n4buq
·
#84563
·
|
Re: Noisy Lower Bands
At my house it¡¯s the xyl¡¯s wash machine!
AE8EA
By
william pinkava
·
#84562
·
|
Re: TR7A Meter spikes
Just tested mine using same settings and don't see meter swinging right after completion of character send during short CW delay settings.
I did have a 40M parasitic oscillation but sounds different
By
Craig W8CS
·
#84561
·
|
TR7A Meter spikes
The situation:
When I transmit on CW and let up the key, the meter goes to the power out during key-down, as normal. When I let up the key at the end of sending, the meter swings hard to the right
By
Steve Wedge, W1ES/4
·
#84560
·
|
Re: Noisy Lower Bands
I wonder if this might be a new Over-the-Horizon radar system?
Lint, VE3CMQ
Sent: Friday, 25 April 2025 12:06
To: [email protected]
Subject: Re: [DRAKE-RADIO] Noisy Lower Bands
By
Clint VE3CMQ
·
#84559
·
|
Re: Noisy Lower Bands
On Friday, April 25, 2025 at 12:37:39 PM EDT, n4buq <n4buq@...> wrote: I hear it also mainly on 80 meters as that is where I mostly operate.? I have no idea what it is.The s-meter
By
Ralph Mowery
·
#84558
·
|
Noisy Lower Bands
While listening to my TR-4 late yesterday evening, I noticed that the lower bands had a prominent, continuous "swish-swish-swish" noise at about 2 or 3 Hz. I checked and I was also getting that on my
By
n4buq
·
#84557
·
|