开云体育

My first rig was a Heathkit HX-10 Marauder with a Drake 2-B and a Dow Key relay. I'm pretty sure that the 2-B got muted from the TX rcvr-mute out of the accessory jack. Just a relay that opens the

Yes, I live in Switzerland. My asking price would be USD 1500.- including shipping. The original paper service manual is included. Freundliche Grü?e Fernando Mobile gesendet Am 12.02.2025 um 09:26

I'd of course be interested.However it depends upon price. Are you in Switzerland?Shipping to the USA would be somewhat costly. Doug/WA1TUT

Dear friends, I have a wonderful Drake DSR-2 in excellent condition. It works perfectly. Would anyone be interested in this device? Best Regards Fenu

Absolute utter? nonsense.? ?The 100k eq resistor across each lytic is to equalize the V drop across each cap.? 2650 vdc / 800k = 3.3 ma of eq current..... = 8.77 watts total or? 1.09 watts per

Yes !? ?At the junction of the plate and grid meter..... it goes off to the CT of the fil xfmr...(with the yellow stripe).? From there it goes out either side to the ends of the fil xfmr sec

Wing it. I replaced all except the meter with white LED. The result was interesting. /g/DRAKE-RADIO/photo/201909/2315369?p=created%2C%2Cuv3%2C20%2C2%2C0%2C0 "George Rybicki via

I'm planning on using a 2B receiver as part of a vintage station along with a DX-20 transmitter (50W input). I have a Dow-Key coax relay which has auxillary contacts. If I use those contacts to mute

Would that account for the filament transformer with no voltage on the center yello tap that goes to the bias?

You’re welcome Ed, it’s a classic amp and they are sought after. Easy to service, responds well to upgrades, built like a tank. Tom W9TAB

Yes I do. Ed [email protected]> wrote:

Thank you much, Steve! Scott

Those are fibre washers, Scott. A little difficult to find but probably available. The panel is easy to remove. Keep track of which knobs have no setscrews and return those to the same shafts

Replacing that panel is pretty easy, just don’t lose those spacers. Of course you need to remove all of the knobs, and the 4 slotted screws on the corners, but that’s pretty obvious. The clear

I am now putting together a T4XB and R4B twin station....and I paired it with a NOS Shure 444D. Looking forward to operating some old school. 73 Scott N1IA

Hello, I have chance to get a new T4XB front panel to replace the one I have which is scratched some. Is it difficult, and what should I watch out for?? I have the bottom cover off for another reason

Ed......Do you still have the original owner's manual?? ....Dave

Well sometimes a break from the task and coming back with fresh eyes helps. ?I didn’t realize it but my function switch was on x-CE closing my transmit relay. I had the radio upside down and never

I resurrected this thread because I've got a couple of nice TR-3s? with not so good soup can xtal filters.? I also have a wrecked TR-4, mid to early production, with the single filter box.? I think

Is there an approved or recommended procedure or do I have to wing it. Thanks George K4MLB